PBS 7.2 (Himedia) adjusted to pH 7.0 stored at 4-8 °C in refrigerator
You can store it for 1-2 months. Try storing it at room temp. Refrigeration temp. can cause salts to precipitate.
No bacteria, no problem.
New prepared PBS or medium solution can be kept longer up under refrigerator temperature. And should be used within 1 week.
What are other good indicators of quality journal apart from high impact factor
10 November 2018 7,971 24 View
I want to prepare lactic acid bacteria from SEM study
31 December 2017 2,320 3 View
I tried both MS paint and MS word, then saved as image but DPI is 96, conversion from 96 to 300 DPI through software dose not improve image quality, I am looking for direct method to save Excel...
08 September 2017 1,900 43 View
How to prepare 20 mM sodium acetate buffer (pH 4.6)
06 July 2017 8,425 4 View
How to prepare 100 ml HCL-KCL 10 mM buffer, pH 4.6Will there be a change in pH after autoclave?
04 May 2017 9,292 2 View
I want to add tertiary vertical axis in line graph as seen in attached picture
04 May 2017 4,595 4 View
Does Journal Impact Factor Really Matters when getting PhD?
31 December 2016 7,904 6 View
Can I get Gene accession number by submitting single strand 16S rDNA sequence of bacteria to NCBI or Double strand 16S rDNA sequence is required for this purpose?
31 December 2016 10,137 6 View
How to submit single strand 16s rDNA gene sequence to NCBI and create phylogenetic tree
31 December 2016 5,022 9 View
Read 6 answers by scientists with 6 recommendations from their colleagues to the question asked by Muhammad Saleem Kalhoro on May 5, 2016
04 May 2016 8,387 7 View
I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...
09 August 2024 9,621 0 View
Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...
09 August 2024 2,824 3 View
I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...
07 August 2024 7,535 4 View
I would like to understand potential safety concerns while handling SEB in the lab. Especially while working in animal house facility. Would like to know precautions for handling. Sigma MSDS...
07 August 2024 6,034 3 View
Does anyone tried to do nucleofection with AMAXA by Lonza with lower than recommended amount of buffer in the cuvettes (100 ul)?
07 August 2024 4,616 0 View
Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.
07 August 2024 8,782 3 View
Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...
07 August 2024 8,106 4 View
Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...
06 August 2024 641 2 View
Currently, when I run SDS-PAGE, I don't see any bands at all, even though I used the same material just a day ago and it worked fine.... In our lab, we dilute the 10X running buffer to 1X and...
06 August 2024 5,373 2 View
Hi, I know that low molecular weight (MW) molecules generally tend to have higher mobility, while high molecular weight molecules tend to have lower mobility. However, in my experimental...
06 August 2024 1,495 2 View