How I calculate the total bacterial count using flow cytometry?

More Ghf Ghf's questions See All

How can I do Ribosomal Intergenic Spacer Analysis RISA?

Hi, I use the primers (S926F and L189R) for ISR amplification by using PCR after the isolation of bacterial DNA. primers targeting the 3' end of the 16s and the 5' end of the 23s to amplify the...

07 September 2015 8,409 2 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

Issues with Permeabilization during Flow Cytometry?

Hello Everyone. Currently I am working to characterize macrophages in the myocardium after ischemia-reperfusion injury in rats. Due to the low total cell number isolated from rat hearts I can...

01 March 2021 3,867 3 View

I want to performe MALDI-TOF MS for bacterial identification, I would appreciate it if anyone can tell me the matrix solution preparation protocol ?

based on what I've studied on multiple papers, for peptide and protein identification Alpha-cyano-4-hydroxycinnamic acid (CHCA) is an appropriate matrix to use, I also know that the CHCA powder...

26 February 2021 6,799 3 View

Why do the air flow results vary totally when adding scalar in CFD ?

Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...

25 February 2021 9,602 4 View

Unknown debris sheets observed in cell culture flasks?

Hi, We culture neural progenitor cells in T175 culture flasks coated with PLO-Laminin. We have successfully grown these cells with our protocol for months. Recently, we observed large sheets...

25 February 2021 3,443 4 View

Universal bacterial primers targeting a mRNA?

Hi, I'm looking for universal primers targeting a bacterial mRNA to quatify bacterial load by qPCR in a complexe mixture (eukaryote and prokaryote RNA). Ribosomal RNA being depleted, I absolutly...

22 February 2021 9,969 3 View

Why anti-CD20 or other antibodies are not used to label target cells in flow cytometry t-cell cytotoxicity assay?

New to the field of cell therapy. Why fluorescent-labeled antibodies to target cell antigens are not used for determining target cell count by flow cytometry in cytotoxicity assay (eg car-t)? Cell...

21 February 2021 3,278 3 View

Does anyone have any ideas why drug-resistant malaria is increasing in Southeast Asia even when those drugs are no longer used?

When dealing with bacterial toxins, there are three varieties of microbes that develop in your petri dish: toxic, resistant, and susceptible. Initially, there are only toxic and vulnerable...

21 February 2021 6,084 5 View

How to calculate time-averaged fields from Ansys CFX solver?

I would appreciate any comments on the following problem. I need to calculate mean fields (e.g. pressure, velocity and vorticity), for which I activate Trn Stats tab in CFX-Pre. However, what I...

21 February 2021 8,548 7 View