The simulation, I am trying to bring about, is essentially related to a contact analysis between deformable and analytical rigid bodies, the interaction between them is defined by means of surface to surface contact type. The problem I have encountered is that the job gets aborted and the following errors pop up:
The CPSET or the surface parameter must be specified for history contact output.
The NSET parameter can only be used for bondstat or bondload output.
I have browsed the open source it doesn't seem that the solution has been explicitly explained. I would greatly appreciate if you can help me to debug the above error! Thanks a lot in advance!
it is probably because you asked for history output for a certain node that does not contain some particular outputs that they will have,
you can start over the history output request and just click in the checkboxes the output you really only need.
- Badges
- Science topic