Any ANSYS FLUENT users here, please help me how do I deal with this error message in generating the surface mesh "Error at Node 0: tg-extract-baffles: wta[0](zone) [249]" . I am actually working on a mixing tank, Your contribution will be much appreciated. Thank you.
Dear friend Khadija el Fakkak
The error message you provided is related to the extraction of baffles in ANSYS FLUENT. It seems like there might be an issue with the meshing of the baffles in your model. Here are a few steps you can try to resolve the issue:
If you are still unable to resolve the issue, you may want to seek assistance from the ANSYS support team or online ANSYS user forums. They may be able to provide additional guidance and troubleshooting steps specific to your model and setup.
Hه
If you cannot change the geometry at the point where the mesh is faulty (the geometry may be complicated or have a hole) to correct the mesh, you must use local mesh correction methods in Ansys. For example, mesh the lines leading to that defective point with a smaller size mesh (of course, the mesh size must vary from this point to other points). You need to define some mesh sizing in the lines close to the defective point. The problem may be fixed.
- Badges
- Science topic