Hello everyone.I have performed a set of validation simulations using Fluent to compare the numerical results with the experimental results.The steady simulations have been performed on a periodic geometry using translational periodic boundary conditions in Fluent. So far it’s going all right. My main intention is to perform simulations for parametrized geometries using the Design of Experiments methodology in ANSYS. I am able to parametrize the mesh and geometry, but I am not able to parametrize the mass flow rates in the periodic simulations input conditions. For velocity-inlet or pressure-outlet BCs, there seems to be the “P” logo which means that I can parametrize that particular quantity, but in the periodic flow BC tab, there seems to be no “P” symbol in front of “Specify Mass Flow rate” input box.Is there an way I can parametrize this mass flow rate?