Dear community,
I am trying to generate a revolved solid from a sketch. I made a a profile and then i used the revolve function but then when I clicked generate it now says an error: "No Closed Profiles"
It is clearly closed. but i don't know if there is any option to check where is the opened places exactly?
Thank you in advance.
In ANSYS DesignModeler, you can use the "Check Geometry" tool to verify if your profile is closed or not. The "Check Geometry" tool helps you identify potential issues in your geometry, including open profiles. Here's how you can use it:
If the "Check Geometry" tool identifies open profiles, you can then inspect your sketch closely to locate the open regions and close them properly. Check for small gaps or disconnected segments that might be causing the issue.
After making sure that your profile is closed, try the revolve function again, and it should work without any "No Closed Profiles" error.
Thank you so much for your answers. I solved the problem i've found that there are two endpoints not closed and now my profile is closed and revolved successfuly. Just it will be important for me to know these solutions for future issues. I tried to follow the answer of mr Kristaq Hazizi but i couldn't find the check geometry option in the tools menu. Also, for the answer of mr S M Tarikul Islam i couldn't find the area and perimeter informations in the Details View window after selecting the sketch of the profile. could you please clarify this for me. Thank you so much for all support.
Sincerly
- Badges
- Science topic