How I can enter the compressive strength, tensile strength in ABAQUS???
You can do this using material plasticity. If you use von Mises plasticity then the tensile and compressive yield stresses will be equal.
Sorry.
I do not know how inter compressive and tensile strength data in Abaqus software ?
For example, the tensile strength is 4.3 MPa and compressive strength is 150 MPa .
To create a material, select Material→Create from the main menu bar. An Edit Material dialog box appears in which you can enter a name for the material and create or edit material properties. So, you can change mechanical properties via Mechanical bar.
This might be helpful. Take only few points, if there is convergence problem
may i know how to calculate the parameters from compressive and tensile strength of concrete ?
- Badges
- Science topic