Have you tried in-house preparation of the restriction buffer?

Dr. Godfred A. Menezes @Dr_Godfred_Menezes

11 November 2014 1 9K Report

Have you tried/ succeeded in in-house preparation of the restriction buffer

(For restriction digestion) when you run out of it !!!!

The problem was particularly with the promega product for PFGE. Found other restriction enzymes with more of buffer accompanied.

Badges
Science topic

More Dr. Godfred A. Menezes's questions See All

Is it right to have exactly same acronym (IJPBS) for 2 different journal names?

“International Journal of Pharma and Bio Sciences” (IJPBS)- ISSN 0975-6299. International Journal of Pharmacy and Biological Sciences (IJPBS)- ISSN 2230-7605

08 September 2015 1,039 5 View

What is your experience with 1xTAE buffer for PFGE electrophoresis?

experience with 1xTAE buffer for PFGE electrophoresis!

31 December 2014 1,864 2 View

Is anyone using the NEB Lambda ladder PFG Marker?

NEB Lambda ladder PFG Marker - literature says electrophoresis run is for 48 hrs. We have optimised our isolate plugs for 19 hrs. How do I synchronize it now? One issue is we get 12-13 bands...

10 November 2014 7,800 12 View

What are the prospectives of additives for synergism along with antibiotics against antibiotic resistant bacteria?

Synergism along with antibiotics against antibiotic resistant bacteria!

08 September 2014 9,159 9 View

Why am I not able to change/adjust the parameters (in. switch and fin. switch time and total run time) in the power module of CHEF DRIII?

Have you faced such a problem? If yes, please suggest how was the problem rectified. Its a new equipment, being used for the first time. Under programme block 1, the initial switch time is fixed...

08 September 2014 10,138 4 View

Do we still stick to the idea of three room rule for PCR Laboratory: separate room for extraction; reaction set up; and cycler location?

PCR Laboratory!

07 August 2014 8,981 3 View

Is this social media trend raising awareness of a little-known disease or just trivialising serious illness- amyotrophic lateral sclerosis through IBC

ALS ice bucket challenge!

07 August 2014 1,440 1 View

In a bacterial semisolid stock if there is fungal contamination, how would you separate out the bacteria from contaminant fungus?

Single bacterial semisolid stock (though not the preferred way of stocking) contamination with fungus.

07 August 2014 8,017 13 View

Do you agree that starting with concentrated/ more than required template in PCR is one of the reason leading to false negative/ no result?

False negatives in PCR

07 August 2014 1,442 0 View

What should be the minimum criteria to call a scientific journal as indexed? Please give your personal opinions, as considered in your universities?

Indexed journal!!

07 August 2014 9,317 1 View

AMAXA Lonza nucleofection lower volume of buffer?

Does anyone tried to do nucleofection with AMAXA by Lonza with lower than recommended amount of buffer in the cuvettes (100 ul)?

07 August 2024 4,616 0 View

AUX gas reading problem on QE with full MS and PRM method in one run?

Dear QE-users, In the method where full MS positive mode and PRM mode are used, we always get an incorrect auxiliary gas reading (41 instead of 25). This only happens in this method; other...

06 August 2024 4,953 0 View

Why I can't see any band in SDS-PAGE?

Currently, when I run SDS-PAGE, I don't see any bands at all, even though I used the same material just a day ago and it worked fine.... In our lab, we dilute the 10X running buffer to 1X and...

06 August 2024 5,373 2 View

Why after performing site directed mutagenesis ,I don't see any colony after transformation?

I want to introduce a point mutation (change in one nucleotide) into my gene of interest (DNA binding domain) I have designed primers as recommended on the Data sheet of the kit : -Both primers...

05 August 2024 9,059 3 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

People weight in Oaxaca Blinder Decomposition on R?

Hello guys! Do you have experience running a Oaxaca-Blinder decomposition on R applying person weights. How do you suggest doing it? I have a variable PERWT which gives more information on how...

04 August 2024 6,033 0 View

What is the best blank for nanodrop if I want to read a recombinant protein concentration?

Is it the "elution buffer" or the "dialysis buffer"? Note: I'll be using NanoDrop OneC

01 August 2024 967 3 View

Recovery rate after peptide desalting using Sep-pack C18 1 cc Vac Cartridge?

Recently I'm trying to use Sep-pack C18 1 cc Vac Cartridge (Waters: SKU: WAT054955) to desalt digested peptides. However, the recovery rate is usually 40-60%. What is the normal recovery rate?

31 July 2024 6,544 11 View

How to perform EEG source analysis on each trial of data separately?

Hello Everyone I have a question about structure for connectivity analysis on sources. My goal: preprocess and cut data into trials create headmodels, using template MRI file perform source...

30 July 2024 2,744 1 View

How to add Cr parameter in autodock?

When I run autogrid4 it says: autogrid4: ERROR: Unknown receptor type: "Cr" -- Add parameters for it to the parameter library first! Look forward to your reply.Thank you so much!

29 July 2024 488 0 View