I want to know what the determinants give a clear idea about the boundary of binodal and spinodal for PVDF dope solution and other membrane cast solution.
The polymer concentration and external and internal liquid bath were the most important factor on the spinodal or binodal
Thank you for your recommendation
Best Regards
Qusay
Hello everyone, I am currently developing a thesis proposal and would appreciate your input on its viability and how to effectively carry it out. My proposed topic is: "Does the perceived threat...
10 August 2024 8,992 0 View
I would like to perform transfection with the reagent DharmaFECT Duo (Horizon) on the AGS cell line. Could you please inform me of the optimal concentration to use without causing cytotoxicity in...
03 August 2024 3,851 1 View
I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...
03 August 2024 6,070 3 View
HI there, I've came across several articles discuss about random audit an Non random to tax evasion or compliance. Most of the articles is relating about effect of audit (random or non random)...
31 July 2024 5,309 7 View
I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...
31 July 2024 9,697 0 View
Please suggest basic literature on lattice-based cryptography. A kind response from the cryptographic community will be highly appreciated.
24 July 2024 6,291 4 View
I want to know that n-doped side of solar cell is connected with positive or negative electrode.
20 July 2024 1,348 2 View
I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...
16 July 2024 3,212 5 View
Bioinformatics tools like peptide cutter
15 July 2024 6,453 1 View
Hello I am trying to simulate repulsive force of two permanent magnets in Abaqus. I have implemented Force equations into a vdload subroutine. sensitive parameters are the center to center...
15 July 2024 3,491 0 View
I am trying to coat my micelles and PLGA based nanoparticles with cell membrane using an Avanti mini extruder according to literature . I use 200nm membrane but my particles end up to be 400nm And...
30 July 2024 3,294 3 View
Does it exist some special technique for cutting ceramic membranes for Cross-sectional FESEM or SEM images?
25 July 2024 5,482 2 View
I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...
22 July 2024 3,490 2 View
Suppose a material "A" has both tetrahedral and octahedral sites and we are doping another material "B" - usually an ion into it. How can we detect if the dopant has occupied the octahedral site...
17 July 2024 4,299 4 View
Hello, I am currently working with Malaria Pf/Pan nitrocellulose membranes coated for malaria detection. After drying the coated membranes in an Incubator (overnight at 37°C), I've noticed that...
16 July 2024 7,937 1 View
we have a nafion 117 membrane and we want to know if it has the properties claimed by the sellers. what are the tests available ?
13 July 2024 503 1 View
could Nd (Neodimyum) doping into TiO2 because Nd's dense diameters are bigger than in TiO2
11 July 2024 2,350 2 View
NA
11 July 2024 8,969 1 View
I am getting trouble in studying the effect of channel doping variation in forksheet structure for p and nmos.
08 July 2024 2,074 0 View