Dear Researchers.
I am trying to resolve the following physical problem. using ANSYS 2021 r1.
Electromagnet that has a coil of 165 turns and 0.0031H and powered by 25 A (AC/DC pending on need) that attract and release a plate standing parallel to it.
I tried to use ANSYS magneto-static to represent the flux density and the force so I made the structure of an electromagnet represented in the picture attached
Running ANSYS magneto-static result in fail due to the following error, despite of trying all the suggested solution yet I am still facing the same issue. (Picture attached)
I tried to switch to ANSYS Maxwell but I could not run it as I had the following error and for the same case I used all the suggested solution about the license and nothing worked.
Please advice
It seems that this error is caused by not having a license for the used module, have you selected the desired module during installation and its license is active on the server?
Yes, I verified the module during installation, and I have active licenses on the server , but the problem remains.
Dear Mohammed
Sometimes, if you install another program, it may change the Ansys server license settings. You may need to make the settings from the beginning again in the license manager. Have you recently installed a new program? Or VPNs may also make unwanted changes.
- Badges
- Science topic