Permanganate oxidizable carbon pH adjustment ?

03 February 2021 1,698 2 View

How can I track the decrease in initiation events of combustion?

Hello, I am interested in tracking the decrease in initiation events of different wildland fuel combustion. Apart from the experimental procedures, is there any simulation software that can help...

12 October 2020 7,895 1 View

Interpretation of Posterior distribution produced by MCMCglmm?

Dear all, I have a comparative phylogenetic model on MCMCglmm, with a binary response variable, 4 binary explanatory variables as fixed effects and the phylogeny as a random effect. I would...

29 September 2020 2,157 2 View

How to analyze differences in short-, mid-, and long-term improvements between two groups?

Hello folks! We created two training courses: A (N=25) and B (N=25). Participants were assigned to one of the two groups respectively. They were tested before, shortly after, and 3 months after...

13 July 2020 2,896 3 View

Did anyone find the right input for mush parameter (Amush) in solidification and melting model of ANSYS FLUENT?

Hello! I am currently involved in a Direct Chill Casting Model of an Aluminum Alloy. The model was built both in ANSYS FLUENT and in COMSOL. I am facing convergence issues and i cannot find the...

23 April 2020 8,241 1 View

Is it possible to couple fluid flow, heat transfer, phase change and mechanical stresses on the solidifying shell using COMSOL Multiphysics?

I am trying to simulate DC Casting of Aluminum Alloys in Comsol. I found an example related to Continuous Casting that it couples fluid flow, heat transfer and phase change during solidification...

28 March 2020 3,003 4 View

Is there a protocol for a multicolour fluorochrome cell staining in microplates?

Our laboratory is not equipped with a flow cytometer. Is it possible to stain cell suspensions (i.e. from thymus) in 96 well plates with multiple fluorochrome conjugated antibodies and then read...

23 February 2020 1,556 3 View

BaysTraits analysis: Using random sample of trees or most probable trees?

Hello. I want to run an MCMC analysis on BayesTraits using a set of Bayesian trees I created using MrBayes. I want to run the analysis using both the consensus tree and a sample of 1,000 trees to...

28 July 2019 5,847 2 View

Can you specify the gene type in a partition file?

Hi! I am trying to build a phylogeny using a mixture of mitochondrial and nuclear protein-coding genes and rRNA genes. Is it possible to specify the specific type of gene in the partition file? I...

16 December 2018 6,025 3 View

Step by step calculation of Lithium Diffusion Coefficient using EIS measurement ?

Hello ! I am trying to figure out how Dli (Lithium diffusion coefficient) is calculated. A method is from EIS measurement. Specifically, from the relationship between Warbung impedance and the...

06 December 2018 9,406 11 View