Hi guys!
I am working on this particular analysis, where I am using frictional contacts. While meshing I used hard behavior of mesh which allowed me to keep mesh size to minimum possible number.
But now the run has gone in bisection. So I am not sure if that is because of hard behavior of mesh.
Is there any relation between these parameters?
Mohamed Darwish
Yes there is a relation between these parameters as strain hardening is well known to delay the convergence of iterative solutions in non-linear analysis. I don't know whether this is possible on ansys or not but from my experience with other packages one could change the convergence criteria in order to accelerate convergence by increasing the degree of tolerance that he program allows.
0 votes
0 thanks
- Badges
- Science topic
More D. M.'s questions See All
Similar questions and discussions