Does anyone know the MgCl2 or dNTP concentration in Invitrogen's AmpliTaq Gold 360 master mix?

11 January 2023 1 9K Report

I'm trying to replicate an older protocol that used Promega PCR Master Mix (2x), using the master mix I have on hand (AmpliTaq Gold 360)

Frederic Lepretre

Hi Kari

in the safety data sheet inclose you'll find the informations.

all the best

fred

Badges
Science method

More Kari Lyn-Marie Imhof's questions See All

As anybody use Log Response Ratio?

I am new to Log Response Ratio (LRR) and it's use in experimental studies. Can anybody explain how it is interpreted? Thankyou

31 December 2023 8,389 0 View

Subgroup analysis in meta-analysis help?

Hello, I am currently running meta-regression models using 2-3 variables. I have coded my categorical variables and included them with my continuous variables in analysis. Am I correct to assume...

26 December 2023 1,984 3 View

Is a meta-regression coefficient calculated from mean scores standardized?

Hello, I have a run some meta-regressions using CMA software. Rather than analyze effect sizes, I have inputted and examined mean scores (cross-temporal). When looking at my regressions' data...

24 September 2023 6,644 5 View

How to assess reliability of a multi-criteria questionnaire?

I've designed a questionnaire that not only has multiple dimensions, but also multiple criteria, in that every item is rated on multiple criteria, each with a separate rating scale. There are 6...

26 July 2023 3,409 3 View

Can anyone confirm if this is Fall armyworm (Spodoptera frugiperda) or not?

I know Spodoptera frugiperda can look similar to close species like S. exigua, S. litura, and corn earworm (Helicoverpa zea). If anyone can confirm with the images (attached).

29 August 2022 5,943 0 View

Is there a DO probe correction factor required for initial versus final DO readings?

For instance, on the day of the initial DO reading, the probe's calibration value was 8.13 mg/L. On the day of the final DO reading, the probe's calibration value was 7.89 mg/L. This is a...

01 February 2022 3,613 0 View

Can microwave digestion be used to prep TKN samples?

Can the Anton Parr Microwave Go be used to digest sludge and solid samples for the analysis of TKN (total Kjehdahl nitrogen)?

07 September 2021 2,813 4 View

Prepping solids samples for COD analysis using pre-made COD vials?

Hello, I was wondering if it is possible to use pre-made COD vials for the determination of COD in solid samples (high solids anaerobic waste, straw, etc.). I have read various papers of how to...

26 July 2021 7,339 1 View

What does it mean to see a band for uncloned vector and one band for vector with insert from one colony after cloning?

I used gateway cloning to clone my insert into the donor vector. After having colonies, I did a mini prep and ran it on the gel. On the gel I could see a clear band on the right length for my...

14 June 2020 10,003 3 View

Change the spectrum of UV-A/UV-B to UV-C?

Greetings, I am a biologist and biomemetic researcher who is interested in the antimicrobial properties of natural ultraviolet radiation. I am aware that most of the devices that employ UV to...

04 June 2020 7,903 4 View

How to confirm the site-directed mutagenesis result without performing NGS?

I'm cloning a fragment of 3200 nts into plasmid. The cloning was successful, however, 02 amino acids were mutated. Now I want to fix these 02 aa by site-directed mutagenesis technique using...

08 August 2024 4,645 2 View

I can't see the ssDNA band after performing asymmetric PCR. Is there any way to do this?

After performing symmetric PCR, PCR purification was performed. Afterwards, asymmetric PCR was performed using the PCR purification product as a template, but no ssDNA band was confirmed in the...

08 August 2024 1,668 3 View

How can I apply boundary conditions in an orthotropic steel deck numerical model using ABAQUS software?

I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...

08 August 2024 719 0 View

Unusual intensity drop in some sections of chromatograms in DDA?

Hi, we have measured tryptic peptides using both DDA and DIA method on QExactive. In DDA replicates i saw unusual intensity drops occurring at the same sections of chromatograms in DDA replicates...

07 August 2024 3,218 4 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

How much total RNA concentration to be extracted from sorted plasma cells from bone marrow of C57BL/6 mice for RT-PCR ?

i have sorted anti-NP specific plasma cells from bone marrow of C57BL/6 mice at certain times after immunization with variable counts and isolated total RNA using TRIZOL method for RT-PCR using...

05 August 2024 8,835 1 View

"A Markov-like Model for Patient Progression"?

A Markov-like Model for Patient Progression" Markov Chain Monte Carlo (MCMC) Markov Chain Monte Carlo (MCMC) is a powerful computational technique used to draw samples from a probability...

05 August 2024 10,079 0 View

Why after performing site directed mutagenesis ,I don't see any colony after transformation?

I want to introduce a point mutation (change in one nucleotide) into my gene of interest (DNA binding domain) I have designed primers as recommended on the Data sheet of the kit : -Both primers...

05 August 2024 9,059 3 View

Why my colony PCR results of my recombinant bacterial not showing any results?

I am performing ligation of the plasmid and a target gene. The steps I have taken are: 1. Double digestion of the plasmid and target gene 2. Ligation of the plasmid with the target gene 3....

05 August 2024 2,570 3 View

Low-yield gel extraction problem?

I am having an issue with my gel image where my PCR product is not appearing very bright on the gel. When I perform gel extraction, the A260/280 purity value is very low. I used the Qiagen gel...

05 August 2024 9,798 3 View