Separate device for Nitrite and H2O2 can be suggested. Or if there is one that has dual functionality. Thanks
Dear Obafemi Obajemihi, please refer to the attached file, hope it will be usefull. My Regards
@Bouaziz thanks for your message, however I am looking for a portable device that can measure those without the rigors of laboratory analysis.
Due to the nature of my research. Thanks
I think all devices used in the attached file are available as portable devices. Good Luck
@Dr. Bouaziz thanks
I am analyzing the lycopene, flavonoid and phenolic contents of dry fruits compared to their fresh state using the same laboratory procedure. Therefore, I am presenting both results on the same...
13 February 2024 6,757 2 View
It becomes interesting to me to realise that a journal with high IF 9 has an acceptance rate of 82%, while another journal with IF of 2.6 recorded an acceptance rate of 38%. Does lower acceptance...
29 January 2024 8,064 5 View
SEM analysis was used to study the morphology of dried fruits could this be a basis for improved or reduced porosity? Rehydration test of samples revealed significant changes in water uptake in...
25 January 2024 8,511 6 View
Most graphical abstracts have been in image (picture) formats are there any alternative ways of creating it. Thanks.
25 October 2023 2,017 5 View
Unlike journals that ensured ideas that are not author's own are duly cited and referenced, and also, author's ideas/observations could be backed up by citing other peoples work and referencing...
08 November 2022 582 4 View
Please in support of the question, I needed to determine colour change for my dried tomato samples with different treatments. Samples colour properties such as lightness and redness increased...
28 October 2021 1,666 5 View
Dear Esteemed Researchers, a portable device was recently procured in my lab. that can determine the concentration of Nitrite (NO2) in treated water. To calibrate the device a standard solution of...
26 July 2021 6,459 2 View
Ascorbic acid of both fresh and dried samples from UV Spectrophotometer were analyzed, and after plotting the calibration curve and applying the absorbance values, it was observed that higher...
12 May 2021 296 6 View
I have seen for example, Figure 1a popularly used how about using Figure 1A? In addition does same also applies to Table ? Thanks.
03 October 2020 9,762 4 View
I dried tomato samples in a hot-air dryer, varying the air temperature at 3 levels, 45, 55 and 65oC. Result obtained showed that samples dried at 45oC had the lowest colour difference as expected...
21 June 2020 3,627 2 View
Air moisture harvesting Air water collection devices
06 August 2024 5,473 2 View
Hello. I am working on ROS production of two systems: system A is cerium oxide and hydrogen peroxide, system B is cerium oxide nanoparticle, hydrogen peroxide and potassium bromide. I did some...
04 August 2024 5,974 3 View
I heard an explanation about something being a better proton acceptor or lone pair donor but that doesn't make sense. I couldn't explain in in terms of acid-base theory. The hand-waving way I saw...
03 August 2024 9,918 0 View
I'm trying to calculate the tolerance factors of the hydride perovskite and the value calculated by me and the reported values are contradictory. Need more clarity in using the correct ionic radii...
01 August 2024 2,614 1 View
What types of mask designs for metal deposition, to be used in a PVD system, are best suited for perovskite-based solar cells?
31 July 2024 4,835 3 View
Hello Everyone! I am trying to create a metal hydride system where I am trying to create a temperature control with the emphasis on measuring the concentration of the hydrogen with the hydrogen...
29 July 2024 7,577 2 View
For people today, the enigma of the size of the proton still remains enigmatic. However, being myself a researcher in new physical theory which makes it possible to extend the different standard...
28 July 2024 7,823 1 View
In general, when performing a Tafel analysis for corrosion resistance measurements, a line voltage scan is performed from say -250 to +250 mV vs. OCV at low scan speed around 0.125 mV/s. However,...
25 July 2024 7,982 3 View
I have tried to saturate ferritic steel with hydrogen using the electrolytic method and H2SO4. However, the effect was very poor even after 3 days of "saturation". Can anybody help in choosing a...
24 July 2024 4,393 2 View
through genetic modification or metabolic engineering? Is it helpful, good for health ?
22 July 2024 7,811 4 View