Check on protein's proline cis/trans configuration by NMR?

More Peter Rehbein's questions See All

I have a time series data of some biochemical studies ( DNA and Chromosomal damage) which I intend to use to further predict into future ?

I have a time series data of some biochemical studies ( DNA and Chromosomal damage) which I intend to use to further predict into future without necessarily conducting the assay for an extended...

23 February 2021 7,842 1 View

No mRNA increase in PCR after successful transfection in ARPE-19 cells ?

Hello, i am a bit curious about my results. I transfected the human cell Line ARPE-19 with a Plasmid containing a GFP tagged p53 (p53-GFP, Plasmid #11770). After 24h i checked under the...

18 February 2021 3,811 7 View

Do there exist stand-alone permanently in-ground soil-moisture sensors with an installed GSM module, for outdoor use?

Am searching for a stand-alone permanently in-ground soil-moisture sensor with an installed GSM module, for outdoor use. The idea is for the sensor to send a moisture reading via a cellphone text...

04 February 2021 2,047 4 View

What is the easiest way to remove the water from organic solvents?

Hello everyone! I have one question. I have couple of solvents and all of them were pure when they were bought but after some months or years of storage after opening I am not 100% sure about...

03 February 2021 2,154 8 View

Virus neutralization assay in BSL2 lab?

Hi I want to set up a virus neutralisation assay such as PRNT or FRNT at my lab (BSL2), but im uncertain of the bio safety requirements that has to be fulfilled in order to work with...

01 February 2021 5,626 3 View

Using LINK11 to Apply force in ANSYS APDL?

I'm trying to use LINK11 to apply a force as if it was a cable pulling a structure twowards a point in ANSYS APDL. When I solve the model, the deformation of the overall structure is far too...

30 January 2021 7,919 1 View

Cytoflex Flowcytometer, clotting issues and cleaning procedures?

We have been having clotting issues with our Cytoflex S from Beckman Coulter. Back in December 2020, we had to have the tubing system and sample needles replaced, but we are beginning to observe...

28 January 2021 6,897 2 View

Difficulties purifying Outer Membrane Vesicles using a Sucrose Density Gradient: Unable to detect any protein after this process?

I'm currently trying to purify Outer Membrane Vesicles (OMVs) following their extraction from the bacteria I'm working with. After the initial extraction the concentration of protein seems good...

27 January 2021 6,852 3 View

What excamples do you know wasting unused contents of "empty" packaged products?

Most of us use tooth paste more times a day. The empty tube we throw away. I wondered how empty the tube really is. This does not sound being Research? I began to collect empty tubes...

19 January 2021 808 3 View

What is the largest disadvantage in using of face masks at present? What would you like to be improved?

We all use face masks many hours a day. I wonder what are your items you like to be improved. We have the opportunity to write an application for support to a sponsor. Your answers will help us a...

18 January 2021 1,311 4 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

How do I determine the degree of polymerization of PEG 400 based on NMR integration?

Hello, I am working on the photocatalytic degradation of PEG 400. I would like to know if it's possible to determine the degree on polymerization based on NMR integration, or by the MW of the...

02 March 2021 6,186 3 View

Do you know any MR image dataset?

I would like to research on MR images (0.5T and 3T). Can you please suggest some websites that I can download dataset including both 0.5T and 3T MR images? Thank you.

02 March 2021 7,735 3 View

What could be some reasons why unstimulated monocytes are getting activated?

Im doing PBMC isolation -> CD14+ enrichment using magnetic beads -> stimulation setup. My negative control is just cells in cRPMI but they seem to get activated over and over again.

28 February 2021 7,883 3 View

Does the circuit modeling for planar monopole antennas using Foster canonical forms give good approximation?

Hi researchers, I am searching for some accurate way to do the circuit modeling of planar CPW-fed monopole antennas. I have gone through the literature where mostly circuit modeling is done using...

28 February 2021 7,016 1 View

How to include original NMR data in a manuscript?

hello. i am junior researcher. I received a comment from a reviewer that he could not find NMR data in my submitted paper. I had included the NMR graph with explanation and formula to calculate...

27 February 2021 734 4 View

Why initial concentration of Pb not the same as calculated one when testing using AAS?

I am currently doing research on the adsorption of heavy metal using magnetic reduce graphene oxide. I use AAS to determine the concentration of the heavy metal. I prepare the Pb solution with...

26 February 2021 9,580 4 View

Is this the write procedure for acid digestion of soil for heavy metal analysis using AAS?

How to do acid digestion of soil sample with 3:1 aquaregia in an open vessel?

23 February 2021 3,053 7 View

How can I simulate the optical absorption spectrum of a biomaterial (like DNA or protein) in COMSOL?

I need to simulate the optical properties of a biomaterial, namely DNA, in COMSOL. Basically I need to simulate the IR absorption spectrum of a cylinder filled with a 'concentration' of DNA. I am...

21 February 2021 3,043 3 View

How to Study a proton NMR of Graphene prepared by Electrochemical Exfoliation technique?

I performed a Proton NMR of graphene powder prepared by electrochemical exfoliation technique. It shows some peaks. But I can't understand it.

21 February 2021 8,947 3 View