cell culture 3T3-L1 adipocytes. I can grown in DMEM medium with or without pyruvate pyruvate?
please... help
Hi, Orlando.
Usually the growth medium for 3T3-L1 is composed by DMEM F-12+ 1%P/S.
Hi Orlando
Although there are several preadipocyte cell lines reported, I am going to send you a protocol from a book that describe mainly the 3T3-L1 cells, which are best characterized and widely used for molecular biological studies.
I hope it will help you out
Best Regards
Dear Orlando
here is anotherbook which might be very useful for you. its a gift for u.
best regards
Thank you so much Antonio Ruiz Vela, Alessio Reggio and Sibtain Afzal, I appreciate your cooperation
Hi,I also want to know the answer
Hello dears,I will thank you for your answers, I want to culture hepatocyte in Williams medium E, but I am not sure how I do. after the culture how I can resuspend this cells. Do you have a...
01 February 2017 1,676 4 View
I'm isolating islets of Swiss albino mouse, no problem inflating collagenase solution into the pancreas through the bile duct. Without obtaining whole islets Type V collagenase Some suggestions...
03 April 2016 8,546 0 View
I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...
10 August 2024 8,539 5 View
I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...
09 August 2024 9,621 0 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...
09 August 2024 2,824 3 View
I'm cloning a fragment of 3200 nts into plasmid. The cloning was successful, however, 02 amino acids were mutated. Now I want to fix these 02 aa by site-directed mutagenesis technique using...
08 August 2024 4,645 2 View
I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...
07 August 2024 7,535 4 View
I would like to understand potential safety concerns while handling SEB in the lab. Especially while working in animal house facility. Would like to know precautions for handling. Sigma MSDS...
07 August 2024 6,034 3 View
I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...
07 August 2024 5,177 3 View
Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...
07 August 2024 8,106 4 View
Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...
06 August 2024 641 2 View