What is the status of bread making and more bakery foods with the use of insect flour/powder?

Insects have been consumed by human diet since prehistoric times. At present, the idea of looking at insects as food has been getting traction worldwide, also in response to increasing food...

03 March 2021 6,223 5 View

What is the best method for removing power-line interference (PLI)?

In the paper A wavelet-based method for power-line interference removal i... we propose a new method for removing PLI. This method consists in identifying the ECG and noise frequency range for...

29 December 2020 9,233 3 View

How to reconcile two sets of qPCR data from the same sample but acquired with different parameters (Ta, primer cc., etc.)?

17 November 2020 4,272 3 View

No title

Hello! I'm currently studying the influence of adding a mass in a cantilever tip, near to a bifurcation. In order to do it, I simplified a model of the cantilever to a 1DOF...

06 November 2020 3,843 3 View

FTIR new peak assignment Ge np coated with Oleylamine?

Dear All, I've been synthesizing Ge nanoparticles using OAm as a solvent/capping agent. Now I'm in the process of assigning the FTIR peaks of my samples. I've assigned almost every peak in the...

02 November 2020 4,227 2 View

What are the main taxa of above ground arthropods in a silvopasture system in the tropics of Latin America?

Beside dung beetles, I would like to learn more about the diversity of arthropods in silvopasture systems where livestock are kept on rotation. Also what about arthropods diversity in similar...

31 October 2020 6,632 1 View

Can I perform a Benjamini Hochberg FDR correction over p values from different tests?

I'm performing statistical analysis on a time series data, comparing the average amplitude (y axis) between three groups on every 50 ms (x axis). The time series is 1200 ms long (so in total 24...

21 October 2020 3,269 3 View

If sustainability is taught at your university in what department the sustainability course/s is housed? What focus/i has the course/s?

Sustainability is a multidisciplinary field and thus, I am interested in learning what emphases are given to sustainability courses in curricula at universities around the world.

19 October 2020 5,621 11 View

What are the basic to state-of-the-art methods for INDOOR temperature interpolation from sparse measures?

Hello, I'm about to start a new industrial project in which we want to estimate (interpolate) the INDOOR temperature at unknown 3D positions in possibly complex 3D room geometry based on sparse...

28 September 2020 4,137 3 View

Communicating though Python module PyVISA to Keithley sourcemeter and nanovoltmeter, GPIB address?

Currently I am working on the acquisition of electrical contact resistance, for which I will be using a Keithley 2400 sourcemeter and a Keithley 2182a nanovoltmeter. Both of the instruments are...

23 September 2020 4,959 2 View

Does the pressure(-600 mmHg) affects pH?

When I conducted the degassing experiment using decompression under anaerobic condition(and I used ferrous based chelating agent), the oxidized ferric were observerd. So, could you tell me the...

03 March 2021 4,892 5 View

Why can't make aluminum nitride film successfully by use sputter?

We use reactive sputtering process to make aluminum nitride film, and want to make c-axis aluminum nitride film on a silicon substrate, but the crystal orientation cannot be seen with...

03 March 2021 7,975 3 View

Is there any test to determine the cardiovascular risk of patients with obesity? from the perspective of obesity?

We found tests to determine cardiovascular risk taking into account lipid profile, blood pressure, age, history of diabetes, other laboratories. But when weight is involved, there is a paradox. I...

02 March 2021 6,036 1 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

Why almost every element would be metallized in sufficiently high pressure and low temperature?

(This statement is from wikipedia, BTW). What is so special about metallic bond that is limiting high-P low-T state of a matter (as long as individual atoms exist, not white dwarf of neutron star...

02 March 2021 3,309 2 View

Sutter electrode holder leaking after applying positive pressure. How to fix?

I am using a Sutter electrode holder for my patch clamp experiments, but I'm having trouble keeping positive pressure inside my electrode due to a leak out of the back of the holder. I have added...

02 March 2021 5,829 1 View

What SPSS analysis should I run with one IV (with two levels) and two DVs?

Hi, I am trying to figure out which test would be most appropriate to run for the following question: Is there a difference in task blood pressure between smokers and non-smokers? There are two...

01 March 2021 8,235 2 View

How much pressure we can reduce at the outlet to avoid Reverse Flow?

I am simulating Heat Exchanger. I have tried and tested all the methods to resolve this issue from the internet like refining mesh, improving skewness and orthogonal quality ,extending outlet to...

01 March 2021 6,985 3 View

Exit velocity of natural gas from pressurized tank?

Hi Guys. I'm a mechanical engineer and have a bit trouble, would be very glad if you could help me with my questions. I have a pressurized tank which contains Natural Gas at 200 Bar and 293...

26 February 2021 6,253 3 View

Gas sensor response and recovery time independant of flow rate and chamber volume?

I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...

26 February 2021 1,511 3 View