Contact experts in Computational Engineering to get answers
3,194 views 83 posts
Questions related to Computational Engineering
What kind of constraint should be apply to the edges?
01 March 2015 2,567 2 View
Hello everyone, I have two different rectangles modeled in two different cs in ANSY MAPDL. But while displaying in the workplane, the orientation of any of the one cs comes at a time and...
25 February 2015 5,089 1 View
As a simple example, I would like to implement a Kalman-Filter in a level 2 m-file s-function. Because of this, I need a covariance matrix P, which will be updated at every time step (so, the...
19 February 2015 1,549 5 View
I am intending to calculate the energy dissipation during the 1st cycle of loading. i have attached the excel sheet which gives details for the 1st cyle of loading. i will be grateful if anyone...
15 February 2015 2,412 6 View
I am building an NMOS using the devedit Tcad software in silvaco. I would like to know if there is a way to get IV curves using devedit or how to call the atlas function in devedit. Thank you
05 February 2015 9,747 4 View
i am doing welding simulation for that i have to import geometry file which should be in NASTRAN format (.bdf). Does anybody know how to create a geometry file in nastran format (by using any...
02 February 2015 4,228 1 View
02 February 2015 10,088 5 View
02 February 2015 9,893 6 View
02 February 2015 1,621 6 View
02 February 2015 3,966 1 View
Hi, I have drawn a 3D sketch using SolidWorks and created lofted surfaces from this. I have then imported this geometry into APDL and meshed it. Once loaded I am getting gaps where it is obvious...
02 February 2015 9,000 9 View
Hi, Is there a relation between the diameter of cylinder and the mesh size that is to be used in simulations. I am trying to model a 27Dx14D rectangular domain with a cyclinder's centre spaced at...
28 January 2015 964 6 View
Hi all, I am trying to model temperature gradient focusing via joule heating. Electric current was applied at a micro-channel filled with electrolyte. The current then induced joule heating, an...
01 January 2015 749 8 View
01 January 2015 1,216 7 View
I am having transient steam parameters at inlet of a steam turbine (start up curve). Is it possible to calculate the steam parameters at exhaust by formulation/simulation/open software? I am...
11 November 2014 7,962 4 View
My code is not performing well at high Richardson number values!
11 November 2014 2,636 6 View
Thank you for reply
11 November 2014 3,893 4 View
I am doing response spectrum analysis on a water tank. I need to find out base shear, overturning moment, story drift and lateral displacements. After analyzing, SAP2000 does not give these...
11 November 2014 7,980 6 View
09 November 2014 5,191 6 View
08 November 2014 3,799 3 View
07 November 2014 10,130 5 View
I am attempting to simulate a triaxial test in ABAQUS/Standard using the clay plasticity model in the ABAQUS material database. I am using a 3-D cylindrical specimen which contains a single...
10 October 2014 3,930 4 View
I want to model the moving mass (not vehicle) in sap 2000, Can anyone help me?
10 October 2014 6,548 5 View
What type of convergence characteristics does it possess?
10 October 2014 5,445 5 View