Hello everyone,
I have two different rectangles modeled in two different cs in ANSY MAPDL. But while displaying in the workplane, the orientation of any of the one cs comes at a time and eventually both the rectangles are being aligned along a single cs, which is not desired. Any kind of suggestions to this problem would be of great help. Thanks in advance.
Srihari Palli
You may use the select menu, and in that try select entity by attribute or material type. Then plot areas. You will get the selected area.
0 votes
0 thanks
- Badges
- Science topic
More Emon Barua's questions See All
Similar questions and discussions