rGo by heating GO
sample is getting out by tube
Argon soygaz olduğu için numune üzerinde radyoaktif veya kimyasal tepkime verir.
I fabricated Ti3C2Tx using concentrated HF 40%, I plot an XRD as attached image below.. please let to know if I obtained it or not.
02 August 2024 6,788 4 View
I need to plot cycle number vs. capacity with multicurrent density. please let me know if my steps are right or not as the below picture
14 July 2024 7,702 2 View
I prepared h-BN by hydrothermal methods by boron anhydride and urea after hydrothermal I was heated at 800 temps for 12 hours after that my sample stuck to the crucible the third time, and the...
15 May 2024 7,354 0 View
I fabricated nanocomposite using the sol-gel method with a mole ratio (1:1) I want (10g) of the final product ZnO-TiO2( molar mass-161.246g/mol) the calculations of the raw materials are as...
13 May 2024 1,731 5 View
i prepared graphene oxide by modified hummers method
13 May 2024 5,162 2 View
MgO NPs were synthesized by sol-gel method. i got Raman peaks at 1022 and 1400
09 May 2024 1,026 3 View
I need this synthesis by hydrothermal method
06 May 2024 1,866 4 View
Actually, I prepared a large amount of MgO, after aging I kept it in a hot air oven at 120 for 12 hours, but there was still moisture there, then I kept it again in a hot air oven at 120C for 6...
05 May 2024 6,279 2 View
because I prepared magnetite by sol-gel method, I got XRD peaks, but for Raman, I didn't get a peak at the range 600cm-1, should I change the wavelength of the laser, or what do I have to do
05 May 2024 2,244 4 View
microwave
16 April 2024 10,005 4 View
Hello experts, Does anyone know any free software about retention index prediction ?
08 August 2024 7,401 2 View
Dear QE-users, In the method where full MS positive mode and PRM mode are used, we always get an incorrect auxiliary gas reading (41 instead of 25). This only happens in this method; other...
06 August 2024 4,952 0 View
Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?
06 August 2024 977 5 View
There are anaerobic gas pak jars and environment providers in the laboratory that provide anaerobic environmental conditions for the growth of anaerobic bacteria. However, there is no anaerobic...
05 August 2024 4,944 3 View
or we can collaborate
01 August 2024 6,704 2 View
99% pure ethanol was used for maceration also alternate methods along with the temperature and time to concentrate the extract can be specified
31 July 2024 5,111 4 View
Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container
30 July 2024 7,326 1 View
I am working on algal extract to which gas chromatography (Not GC-MS) spectrum I want to discover. My question is can we identify specific compounds using retention time if I compared the RT with...
29 July 2024 8,032 4 View
I have different polymer solutions and I hypothesize that water molecules are retained based on the water-polymer interactions, so the amount of free water is less to intercat with drug tablet....
28 July 2024 9,544 6 View
List down the various factors responsible and how does this effect the overall biogas production when it is related to Hydraulic retention time of the digester based on the feedstock?
27 July 2024 4,800 4 View