I need to plot cycle number vs. capacity with multicurrent density. please let me know if my steps are right or not as the below picture
It seems correct,
Akshay Hegde thank you
I fabricated Ti3C2Tx using concentrated HF 40%, I plot an XRD as attached image below.. please let to know if I obtained it or not.
02 August 2024 6,788 4 View
I prepared h-BN by hydrothermal methods by boron anhydride and urea after hydrothermal I was heated at 800 temps for 12 hours after that my sample stuck to the crucible the third time, and the...
15 May 2024 7,354 0 View
i prepared graphene oxide by modified hummers method
13 May 2024 5,161 2 View
I fabricated nanocomposite using the sol-gel method with a mole ratio (1:1) I want (10g) of the final product ZnO-TiO2( molar mass-161.246g/mol) the calculations of the raw materials are as...
13 May 2024 1,731 5 View
MgO NPs were synthesized by sol-gel method. i got Raman peaks at 1022 and 1400
09 May 2024 1,025 3 View
I need this synthesis by hydrothermal method
06 May 2024 1,866 4 View
Actually, I prepared a large amount of MgO, after aging I kept it in a hot air oven at 120 for 12 hours, but there was still moisture there, then I kept it again in a hot air oven at 120C for 6...
05 May 2024 6,278 2 View
because I prepared magnetite by sol-gel method, I got XRD peaks, but for Raman, I didn't get a peak at the range 600cm-1, should I change the wavelength of the laser, or what do I have to do
05 May 2024 2,243 4 View
microwave
16 April 2024 10,005 4 View
rGo by heating GO sample is getting out by tube
02 April 2024 1,719 1 View
How is energy cycled through the Earth's climate system and how do matter cycle and energy flow through the rock cycle?
08 August 2024 8,159 0 View
I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...
08 August 2024 8,328 0 View
Hi, I'm currently working on a project where I need to plot the atom-projected band structure using GPAW. I've been able to calculate the band structure for my material, but I'm having trouble...
07 August 2024 266 3 View
I am experimenting with cancer and non-cancer cells in a 12-well plate for 4 days with a seeding density 1*10^4/well, however, I noticed that the control group growth rate slows down on D3. Should...
07 August 2024 2,282 2 View
Hi all, my experimental XPS results shown that my C3N5 sample consists of N-H bond, hence in this case I should incorporate the N-H bond into my DFT modelling. However, I do notice several papers...
07 August 2024 8,413 2 View
Hello, everyone. I have tried to determine carrier motilities of some materials, by Density Functional Theory, using Quantum ESPRESSO. There are a few methods to do it, like a package called...
04 August 2024 8,890 1 View
How are the movement of energy in an ecosystem different from chemical cycling and movement of matter through an ecosystem differ from the movement of energy?
03 August 2024 6,134 0 View
I imagine the battery drives the graphite into a carbocation, then chloride is oxidized to donate the electron to the carbocation, but what pushes the lost electrons of chloride to be shared...
03 August 2024 5,384 0 View
Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity? What is the acceptable percentage of error (regardless of the metric)? Could you suggest...
03 August 2024 5,357 0 View
How does matter cycling and energy moving through the ecosystem differ from one another and cycling of matter through the ecosystem?
03 August 2024 2,557 1 View