Why not poisson ratio calculated by linear deformation divided by lateral deformation.
Dear bala ,because its a ratio between elongated to lateral strain,strength of material/(Tomeshenko)
I know that youngs modulus is material property but am not clear about stiffness how vary?
31 December 2018 6,215 5 View
In bending stress, whats different between endurance limit vs endurance strength?
31 December 2018 1,710 2 View
Is reduced integration affect the analysis results in Abaqus CAE.
31 December 2018 6,367 4 View
Am just troubling to assume that which is dependent or independent surface while interaction constraint applying.
31 December 2018 396 3 View
How to fix the Element distortion error in Abaqus?
31 December 2018 8,696 3 View
I am doing bolt load and torque load sequentially. But not sure that my result going to valid.
31 December 2018 2,414 3 View
Am doing dynamic analysis with penetration error, am not sure that my result correct or wrong.
31 December 2018 6,738 3 View
When observed ,Why most of the biscuit or cookie packaging cover have glittering coating(like silver or aluminium foil ) given inside it ?
11 December 2018 2,013 2 View
Hi I want to clarify about geometry property can affect or change the materials data?
11 December 2018 8,694 0 View
what's the breaking stress and strain value for Al 7050 T7351 material
11 December 2018 5,608 2 View
I want to explore the long-term effects of incarceration on a youth's developing brain. I also want to explore research that looks critically at incarceration and punitive measures as the primary...
12 August 2024 862 0 View
I would like to learn more about SPSS and Its application especially in regards to data analysis. Please suggest me how I can learn more about it. Thank you so much.
11 August 2024 9,101 4 View
I have reverse sequences (AB1 format), can I base on reverse DNA sequences to perform nucleotide alignment, convert nucleotides to amino acids and deposit the sequence in GenBank database?
11 August 2024 5,138 1 View
Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!
11 August 2024 3,770 4 View
Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...
10 August 2024 7,180 0 View
I'm currently exploring the application of Python in textile engineering, specifically in areas like data analysis, process automation, and the development of smart textiles. I'm interested in...
10 August 2024 7,429 2 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...
07 August 2024 1,937 1 View
A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.
07 August 2024 5,307 1 View
I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...
07 August 2024 5,177 3 View