Why NIST database have not LIBR+H2O for experimental data ?

01 January 1970 1 5K Report

why NIST database in ASPEN PLUS have not LIBR+H2O for experimental data ?

Hello there.

There are many compounds that are not found in ASPEN databases, new ones are incorporated in each version, but many are still missing.

One option that you have is to be able to create pseudo components and add them to ASPEN.

I leave you some tutorial links.

https://www.youtube.com/watch?v=TTQmX7ZhIb0

https://www.youtube.com/watch?v=btfE1tAmJK8

https://www.youtube.com/watch?v=791AKUFPIa8

Regards.

Badges
Science topic

More Cenker Aktemur's questions See All

How can I calculate horizontal and vertical wheel load according to Figure?

How can I calculate horizontal and vertical wheel load according to Figure ? There is no specific reference book. I need to calculate horizontal and vertical wheel load (4 wheel and 8 wheel)

15 November 2023 1,080 0 View

Why exergy cost of overall system is only 14.582 $/GJ?

Why exergy cost of overall system is only 14.582 $/GJ? Isn't the solution pump a fuel too? Why didn't you include it? Shouldn't it normally be 24,582 $/GJ?

24 November 2022 5,652 0 View

Why exergy destruction rate of solution expansion valve in absorption refrigeration system is negative?

I designed LiBr/H2O single effect absorption refrigeration system using Aspen Plus. Energy analysis is OK. However, exergy destruction rate of solution expansion valve in absorption refrigeration...

23 August 2021 7,359 4 View

Why temperature increases with adding nanoparticle to base fluid?

THEORETICAL QUIESTION Adding nanoparticles to the base fluid, for example, causes a significant increase in the temperature of the evaporator. What is the reason of this? I want to operate...

11 July 2021 5,662 6 View

Desired cooling capacity should be given as input parameter in ejector expansion vapor compression refrigeration systems?

desired cooling capacity should be given as input parameter in ejector expansion vapor compression refrigeration systems? if it is given, COP value is higher than non-given cooling capacity? i'm...

23 June 2021 6,077 0 View

Is it possible to calculate entalphy of LiBr/H2O or another solution if we know correlation of specific heat without using any software?

17 January 2021 5,917 3 View

How can I define the mixture in Aspen Plus: "Potassium formate-Water-AL2O3" ?

How can I define the following mixture in Aspen Plus: "Potassium formate-Water-AL2O3" If you know, could you please explain step by step via some screenshots from Aspen Plus ?

22 December 2020 5,346 3 View

Potassium formate/water or potassium formate+LiBr/Water are not available in the commercial sector for absorption refrigeration systems?

Although there are already studies in the literature but not much , the use of potassium formate/water or potassium formate+LiBr/Water are not available in the commercial sector for absorption...

16 November 2020 3,146 2 View

Fuel and product exergy rates ?

How to write the fuel and product exergy balances in the cascade heat exchanger in the cascade refrigeration system?

22 September 2020 2,152 4 View

Add heterogeneous catalyst substances to LiBr-Water for absorption refrigeration system ?

Is it possible to add heterogeneous catalyst substances to LiBr-Water for absorption refrigeration system ? If yes, how ?

03 May 2020 7,130 0 View

How to learn more about SPSS and its Application?

I would like to learn more about SPSS and Its application especially in regards to data analysis. Please suggest me how I can learn more about it. Thank you so much.

11 August 2024 9,101 4 View

Can I base on reverse DNA sequences to perform alignment, convert to amino acids and GenBank submission?

I have reverse sequences (AB1 format), can I base on reverse DNA sequences to perform nucleotide alignment, convert nucleotides to amino acids and deposit the sequence in GenBank database?

11 August 2024 5,138 1 View

Baseline drift in HPLC? What causes this?

Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!

11 August 2024 3,770 4 View

Text-Communication from the M1 Hand Area using BCI—and then there is Elon Musk?

Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...

10 August 2024 7,180 0 View

Has anyone applied Python in the field of textile engineering for data analysis, automation, or smart textiles?

I'm currently exploring the application of Python in textile engineering, specifically in areas like data analysis, process automation, and the development of smart textiles. I'm interested in...

10 August 2024 7,429 2 View

How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?

09 August 2024 7,718 0 View

How are iso-frequency contours plotted?

Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...

07 August 2024 1,937 1 View

How to prepare the nanoparticle treated fungal sample for Environmental SEM analysis?

A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.

07 August 2024 5,307 1 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

Aspen Plus Simulation?

Greetings When one is to perform Simulation or modelling of Pyrolysis of Biomass Waste materials using Aspen Plus software, and one has both the macromolecules breakdown (Cellulose, Lignin and...

06 August 2024 5,023 1 View