Why temperature increases with adding nanoparticle to base fluid?

More Cenker Aktemur's questions See All

Is it possible to calculate entalphy of LiBr/H2O or another solution if we know correlation of specific heat without using any software?

17 January 2021 5,522 3 View

Potassium formate/water or potassium formate+LiBr/Water are not available in the commercial sector for absorption refrigeration systems?

Although there are already studies in the literature but not much , the use of potassium formate/water or potassium formate+LiBr/Water are not available in the commercial sector for absorption...

16 November 2020 2,917 2 View

Fuel and product exergy rates ?

How to write the fuel and product exergy balances in the cascade heat exchanger in the cascade refrigeration system?

22 September 2020 1,954 4 View

Nanoparticle for absorbtion refrigeration system ?

How can concentration in terms of rich and poor be affected by adding nanoparticles to LiBr-Water?

23 March 2020 6,718 7 View

1)A question of quadruple integral ??

I cannot solve by maple or mathematica software. Can you help me

16 December 2018 696 2 View

Potassium formate/Water

Although there are already studies in the literature but not much , the use of potassium formate/water or potassium formate+LiBr/Water are not available in the commercial sector for absorption...

01 January 1970 3,749 3 View

Who can help me model the absorption cooling system in Aspen Plus?

I am trying to model a single-effect absorption refrigeration system using LiBr/H2O in Aspen Plus. Who can help me model the absorption cooling system? Please send a private message.

01 January 1970 6,733 6 View

Engineering equation solver

I need the lastest EES software. I already have one but it is old version (2013) . Therefore, some refrigerants are not available in it. If you have it, please inform me.

01 January 1970 6,940 11 View

Calculation of performance parameters of absorbtion refrigeration system with nanofluid?

Hello, My reseacrh area is absorbtion refrigeration system with nanofluid. I know how can I calculate the performance parameters of NH3-WATER and LiBr-WATER as a base fluid. But the thing is, how...

01 January 1970 7,246 3 View

calculator block of mass flow rate in aspen plus

why I need to enter the mass flow rate in stream 1 in aspen plus ? For example, I entered the mass flow rate as 1 kg / sec. I want to change it according to the cooling load of the evaporator but...

01 January 1970 8,047 2 View

I need to image mesoporous silica nanoparticles that are in ~100 nm size and do high resolution TEM to look at mesopores. what grids should I use?

Need to image mesoporous silica nanoparticles using the TEM. Also, need high resolution TEM images to see the mesoporous structure. Kindly suggest what kind of grids to use. Thanks, Shatadru

02 March 2021 1,787 2 View

How to grow E.coli on the low salt LB agar plate with 50 or 100ug/ml of Blasticidin?

Hello, I would like to ask how to grow E.coli which resists 50 or 100ug/ml of Blasticidin. I have tried many methods by using low salt Luria-Bertain(LB) agar plate. However, no colonies grow. Let...

01 March 2021 2,027 2 View

Can chitosan alone can act as a reducing agent for Cu(0) nanoparticle sythesis?

[Synthesizing Cu nanoparticles without using chemical reductants]

01 March 2021 8,359 1 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

What is the state of the drug inside solid lipid nanoparticles (SLNs)?

I am a little confuse with the mechanism of solid lipid nanoparticles (SLNs). The main point of encapsulating drugs into SLNs is because some drugs have low solubility in water. Therefore, SLNs...

01 March 2021 3,703 3 View

How to check the uv-vis absorption of nanoparticle by surface plasmon resonance?

I try to check the uv-vis absorption of Indium nanoparticle. Now I am measuring in solution, can I measure it in the form of a film?

01 March 2021 930 3 View

Distribution of particles in metal matrix?

How would define the "good" and "poor" distribution of particles within the matrix. Is there a quantitative solution to assess the distribution of the particles, which then having denotation of...

28 February 2021 7,397 8 View

How can I calculate the rdf of water molecules around 'Na' ions that are closest(adsorbed) to the nanoparticle(solute)?

Hi, I want to calculate the radial distribution function for water molecules around the Na+ ions adsorbed on the surface of a spherical nanoparticle using the gromacs trajectory dynamically? For...

28 February 2021 5,650 1 View

LEDs on Vis Light photo degradation of MB water sol via N doped TiO2 in a mini flume?

Good day to all, I have no experience with light emitting diodes. I am building a glass mini flume to demonstrate the photo degradation of Methylene Blue in water running over self cleaning...

26 February 2021 4,026 5 View

Can anyone share his experience regards Smoothing in origin?

I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...

26 February 2021 8,183 3 View

Alan F Rawle

Cenker Aktemur

Theoretical answer...

Depends on the nature of the nanoparticles and the liquid which you do not state.

Abdelkader BOUAZIZ

Dear all, do these nanoparticles keep their integrity ? Or they are dissolved, sometimes dissolution is exothermic. My Regards

Alan F Rawle Since the density of the nanoparticle is high, when it is added to the base fluid, the operating temperature also increases. If the operating temperature is rising then why do we use nanoparticles?

Beats me…

Vadim S. Gorshkov

I have not any experimental set up. I'm talking about experimental results in the literature.

Dear all, may be the following document will help understanding the situation you are studying, however in this review an external stimuli is applied to magnetic NP's for heat generation. My Regards

https://doi.org/10.3109/02656736.2013.836758