How can I define the mixture in Aspen Plus: "Potassium formate-Water-AL2O3" ?

More Cenker Aktemur's questions See All

Is it possible to calculate entalphy of LiBr/H2O or another solution if we know correlation of specific heat without using any software?

17 January 2021 5,522 3 View

Potassium formate/water or potassium formate+LiBr/Water are not available in the commercial sector for absorption refrigeration systems?

Although there are already studies in the literature but not much , the use of potassium formate/water or potassium formate+LiBr/Water are not available in the commercial sector for absorption...

16 November 2020 2,917 2 View

Fuel and product exergy rates ?

How to write the fuel and product exergy balances in the cascade heat exchanger in the cascade refrigeration system?

22 September 2020 1,954 4 View

Nanoparticle for absorbtion refrigeration system ?

How can concentration in terms of rich and poor be affected by adding nanoparticles to LiBr-Water?

23 March 2020 6,718 7 View

1)A question of quadruple integral ??

I cannot solve by maple or mathematica software. Can you help me

16 December 2018 696 2 View

Potassium formate/Water

Although there are already studies in the literature but not much , the use of potassium formate/water or potassium formate+LiBr/Water are not available in the commercial sector for absorption...

01 January 1970 3,749 3 View

Who can help me model the absorption cooling system in Aspen Plus?

I am trying to model a single-effect absorption refrigeration system using LiBr/H2O in Aspen Plus. Who can help me model the absorption cooling system? Please send a private message.

01 January 1970 6,733 6 View

Engineering equation solver

I need the lastest EES software. I already have one but it is old version (2013) . Therefore, some refrigerants are not available in it. If you have it, please inform me.

01 January 1970 6,940 11 View

Calculation of performance parameters of absorbtion refrigeration system with nanofluid?

Hello, My reseacrh area is absorbtion refrigeration system with nanofluid. I know how can I calculate the performance parameters of NH3-WATER and LiBr-WATER as a base fluid. But the thing is, how...

01 January 1970 7,246 3 View

calculator block of mass flow rate in aspen plus

why I need to enter the mass flow rate in stream 1 in aspen plus ? For example, I entered the mass flow rate as 1 kg / sec. I want to change it according to the cooling load of the evaporator but...

01 January 1970 8,047 2 View

what is the simplest definition of ion exchange capacity

What this unit identifies for the ion exchange capacity ca. 0.92 meq. g-1. I am a newcomer in the membrane area. I just started. I highly appreciate your help

08 May 2021 0 0 View

what is the simplest definition of ion exchange capacity

What this unit identifies for the ion exchange capacity ca. 0.92 meq. g-1. I am a newcomer in the membrane area. I just started. I highly appreciate your help

08 May 2021 0 0 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence?

I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance

03 March 2021 3,568 1 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View

How to increase a model accuracy ?

dear community, my model is based feature extraction from non stationary signals using discrete Wavelet Transform and then using statistical features then machine learning classifiers in order to...

03 March 2021 6,994 5 View

How the parameters (such as Mw, Chemical bonds, polymer bland and so on) affect the mechanic property of polymer (such as storage, loss modulus) ?

Anyone can recommend any books on such topics? Thanks in advance.

02 March 2021 8,457 2 View

Do I need to do linear regression before running mediation analysis using PROCESS MACRO by Hayes ?

I just wanted to check if I need to run a linear regression separately if I am using PROCESS MACRO to run mediation analysis. Thank you.

02 March 2021 4,359 3 View

Sampath Suranjan Salins

Is this Ansys Fluent analysis? its multiphase flow problems. U need to model the packing first the define the desiccant and material. Then apply suitable boundary conditions to solve the problem.

Cenker Aktemur

Sampath Suranjan Salins I am not talking about ansys. I AM DIRECTLY TALKING ABOUT ASPEN PLUS.

Siddig Abuelgasim