Contact experts in Simulators to get answers
1,672 views 4,579 posts
Questions related to Simulators
I am trying to inject fault in fog devices using iFogSim simulator. How can i inject fault in fog device?
10 September 2023 5,544 0 View
1) During BST (Ba0.5Ti0.5TiO3) deposition on Si, SiO2, Al2O3 substrate after platinum deposition, I am getting porosity in BST sample which creating difficulty in making capacitor of BST thin...
04 September 2023 8,956 1 View
Has OpenAI released any solutions or approaches for task-oriented dialogue?
03 September 2023 5,724 2 View
How can we optimize the flow & consumption of fuel in Aerospace sector using CFD ?
03 September 2023 7,392 1 View
Please tell me if you have any references explaining the f2md code and parameters which it found in f2md code ? I read the f2md code ,but some of parameters not explained in its .
03 September 2023 2,630 0 View
European Gonococcal Antimicrobial Susceptibility Programme (Euro-GASP) has been monitoring the antimicrobial susceptibility in Neisseria gonorrhoeae since 2004. Its EQA scheme is necessary for the...
03 September 2023 5,188 3 View
Let's consider a scenario where an IMU device can be attached to any point around the waist. In this case, the direction of motion, like walking, may not necessarily align with the x-axis of the...
02 September 2023 1,609 1 View
In which region the salinity of seawater is maximum and why is salinity low on the equator and at the Arctic and Antarctic Circle?
31 August 2023 2,126 0 View
In which condition solubility of a substance will increase and which type of substance will increase in solubility when there is a decrease in temperature?
30 August 2023 9,354 6 View
How is the polarization of an em wave change when propagating through fog or rain? Say the wave is initially vertically polarized, how will rain and fog change its polarization?
30 August 2023 7,753 2 View
what kind of securities are provided by the network providers and how much security does the common people received
30 August 2023 8,932 4 View
Which property is best to use when determining the strength of an ionic bond in solid lattice energy conductivity hardness solubility?
29 August 2023 6,909 0 View
In plasma physics, thermodynamic property is influenced by isothermally confined electrons and adiabatically expanding electrons. How can isothermally confined electrons and adiabatically...
29 August 2023 1,715 3 View
I'm struggling to publish my work because I cannot find a good journal with less publication fee as most of the good journals are charging more than $2000. My work is based on colorimetric LAMP...
29 August 2023 7,040 3 View
Hi everyone, I would like to ask that if the reaction can be used with ammonia solution in methanol (7N), because in my place is hard to get pure anhydrous ammonia. I have seen an article that...
28 August 2023 7,819 0 View
I am working on an inhibition assay. I included 10-12 concentrations for the assay to account for the upper and lower plateaus of the sigmoid curve. To make the calculation of IC50 easier, I used...
28 August 2023 2,977 0 View
Dear fellow researchers! I need global data on normalised difference moisture index (NDMI) in raster formats. Is it possible to get it? The AOI is considerably large and going for calculation...
27 August 2023 7,612 2 View
After collecting my data, I decide to test my hypothesis using regression analysis. I also recognized the fact that my data must meet the assumptions of the tool before I can use it. Therefore I...
26 August 2023 1,217 5 View
How is the sun responsible for blowing of winds and which source of energy causes most of the water evaporation on Earth's surface?
24 August 2023 5,117 4 View
In which paper can one find the calculus demonstration for Grenoble's method for uplift piles?
24 August 2023 8,137 0 View
Surface textures is the intentional introduction of well defined features like micro dimples This helps to generate hydrodynamic lift between the parallel surface when they are in relative motion.
23 August 2023 4,236 3 View
The Abaqus user manual describes it as follows: Abaqus/Explicit offers distortion control to prevent solid elements from inverting or distorting excessively for these cases. The constraint method...
23 August 2023 9,838 0 View
Hello, I have a cylindrical enclosure in which a couple of electrical components create heat. In shadow, where radiation can be neglected, I can calculate the max internal temperature based on the...
23 August 2023 4,054 0 View
Could you elaborate on the difficulties and obstacles that arise when training deep neural networks, and how researchers and practitioners have attempted to address these challenges?
22 August 2023 8,399 2 View