Dear Researchers,
I'm running a simulation on calorimetric thermal flow sensors. I tried to use Joule heating and Laminar flow interfaces to obtain the temperature distribution on the surface of the sensor and heater due to air flow . I used two stationary study modes to couple fluid flow and Joule heating. However my model is taking a long time to run and yields no results. Attached here is my model. It would be great if someone can help me out with the model. Thank you
it can be because that there is no enough capacity in the operating disk of your pc
Probably there can be 2 major problems. 1) improper mesh size - results in non-convergence and 2) memory capacity of your server station. Please try to find a right mesh size for your model to properly converge. If mesh size is small, please cross-check your PC memory. I hope this might help.
- Badges
- Science topic