The procedure compute?

02 March 2021 5,204 3 View

One-sided testing of MLM in R?

Dear colleagues, Does anyone know how to conduct a one-sided testing of regression weights (MLM) in R? The actual model is fm1rs

23 January 2021 3,970 3 View

[Measurement invariance] - Do you test it on the full SEM model, on each construct separately, or both?

Hi everyone, I would like to know whether both cultural groups interpreted my questionnaire in a similar way. To do so, I conducted a measurement invariance analysis on the whole model of latent...

14 January 2021 1,845 3 View

Is it possible to do a closed loop control of a sine wave?

An analogue voltage sine wave signal is send from a PLC to a Piezo actuator. This actuator converts the voltage to force. A load cell checks what the applied force is and sends a mA-signal...

27 December 2020 7,037 3 View

[SEM] Why RStudio and AMOS report different p-values (but same estimates)?

Hi everyone, I have conducted a SEM analysis in AMOS then replicated it in RStudio. While I obtained identical estimates and model fit statistics, the p-values differ between software programs...

25 December 2020 3,669 4 View

What should my boundary conditions be in abaqus and how do I apply a sine load?

I want to model a T bone specimen that is subjected to a sine load. The specimen is clamped in as showed on the figure. I was wondering what I should chose as boundary conditions and how I can...

08 November 2020 9,766 4 View

Does anyone know instruments to measure "mental health literacy" in teachers?

Hi there, I am looking for questionnaires measuring mental health literacy in teachers and educators. does anyone know any studies in this area?

16 September 2020 1,682 4 View

Is there any possibility to get the estimated values (listed for every participant) of a specific latent variable in R or Mplus?

Is there any possibility to get the estimated values (listed for every participant) of a specific latent variable in R or Mplus?

17 June 2020 3,819 3 View

Literature for multilevel MCMC models?

Hey there, I am looking for literature or tutorial videos, which are concerned with the question of how multilevel markov chain monte carlo models are conducted in R or Mplus. Can someone help...

20 April 2020 7,801 1 View

How to generate a ROC-Curve for multilevel regression models?

Dear colleagues, Does anyone know, how to build a ROC-Curve and a AUC-Value concerning multilevel logistic regression models using R or Mplus. I would be very grateful for any articles,...

26 February 2020 8,930 3 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence?

I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance

03 March 2021 3,568 1 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View