Which kind of furnace is needed for carbonization of a material in Argon atmosphere?

18 October 2022 1 6K Report

I want to do carbonization on SnO2 particle at 500 degree Celsius in Argon atmosphere. Which kind of box furnace is needed there? Valuable suggestions are welcome!

Arpan Ghosh

Thank you Vivek for your suggestion.

Badges
Science topic

More Arpan Ghosh's questions See All

Is this a facetotecta nauplius?

This larva was captured using a plankton net in the Persian Gulf during the summer. I believe it may be a Facetotecta nauplius.

08 August 2024 3,746 4 View

Z-average size from Dynamic Light scattering can it be lower than the original probe size?

Hi everyone, Recently I have been conducting Dynamic Light scattering experiments in a micellar solution at 5 and gel at 37 degrees of Celsius with latex particles of diameter 190-500 nm. While...

01 August 2024 1,168 4 View

GSH estimation assay: What is the right choice of standard?

Hi there, My question is: What standard curves should be used while estimating Tot GSH and GSSG by kinetic method using GR enzyme mediated recyling with DTNB chromophore? Actually I am following...

01 August 2024 8,217 1 View

Following click reaction in cell lysates, protein is immobile and remains at the top of the gel in SDS-PAGE?

I am using CuBr/THPTA for a click reaction in total cell lysates. I am facing issues with my protein sample in non-reducing SDS-PAGE where it's not migrating properly and most of it remains at the...

29 July 2024 950 4 View

Which filtration method to go for run off water from dirty solar panels to be used again?

We are working on a robot that cleans solar panels using fresh water supply and a rotating brush. We are trying to conserve as much water at possible by recycling the dirty water that is collected...

28 July 2024 5,778 2 View

When making abraxane with Nab tech, why is 9:1 Chloroform&EtOH used as solvents?

Is it the best optimization ratio based on experiments?

22 July 2024 8,170 0 View

Can diamond be grown using molecular beam epitaxy?

22 July 2024 9,755 2 View

Intracerebroventricular (ICV) AAV inj.?

I'd like to know if anyone has got experience in intracerebroventricular (ICV) AAV inj. I am looking for a concomitant spread of the AAV including but not limited to the motor cortex and the...

12 July 2024 781 0 View

How can I use LabVIEW to control of an ethernet-based driver?

Hello everyone, I am new to LabVIEW, right now we need to control the movement of an ethernet-based stage drive. We got the sample code from a collaborator but their instrument is USB-based, so we...

11 July 2024 5,385 2 View

Systematic review meta-analysis paper?

Hi everybody, We are trying to write a systematic review meta-analysis paper. But I could find 19 references. I think 19 references are not enough to do a meta-analysis section and it is better to...

10 July 2024 5,490 5 View

What is the mechanism of atmospheric pressure plasma Jet (APPJ)?

In general, the characteristic of electric current as a function of voltage in argon plasma jet using dielectric barrier discharge in atmospheric pressure, jet length will increase by the increase...

16 July 2024 9,316 1 View

How to directly convert anthracite into Graphene in a simple way?

I read an article (https://doi.org/10.1016/j.synthmet.2020.116364) regarding the direct conversion of anthracite into graphene in the presence of molten. I would like to ask the view from...

05 May 2024 969 0 View

When we pump argon gas into Atomization chamber, then we evacuate using a vacuum pump... Where does the argon gas go?

We use ... Desktop sputter coater device

11 April 2024 5,825 3 View

Can someone suggest me a possible method to prevent activity loss of vitamin D3 over the time?

I am working with vitamin D3 and every time wea re facing problems with storage and lost activity of vitamin D3. We had tried every possible method such as working in low light, storing at...

29 March 2024 5,415 0 View

What is the quantified effect of Inert Gases in reactive etching and reactive ion beam etching for SiO2?

I am struggling to find good resources to reference for justification of dilutant gas (Helium and Argon) use in reactive plasma system. I understand the general argument that the dilutant can help...

09 February 2024 6,996 0 View

Does anyone know of an academic reference for using Argon as an internal standard for ICP-AES?

My assumption is that using Argon as an internal standard for ICP analysis has never worked well, but I'd like to know of any documented publications on this. Much thanks!!

07 February 2024 675 2 View

Can anyone assist on hydrogen reacting with metal hydride?

Hello! I was trying to make hydrogen react with the metal hydride to form hydrogen storage technology, I have verified the connections o ensure no leakage and when supplied , I am not observing...

19 January 2024 10,074 7 View

Is it okay to use liquid argon as an inert gas in a glove box?

Is it okay to use liquid argon as an inert gas in a glove box? I'm currently using argon gas, and it needs frequent replacements, which is inconvenient. I'm wondering if using liquid argon might...

12 December 2023 9,159 2 View

CaCO3 from waste marble?

I want parameter for carbonation (CaO+CO2 to get CaCO3)in low temperature the highest temperature is 450 c with out stirring i want to do this experiment in co2 capture and this instrument only...

10 November 2023 2,064 2 View

Why does sputtering gold deposition result in the formation of a dark iridescent coating on both samples and the chamber?

Dear Researchers, I typically apply a gold deposition of 5-10 nm thickness on samples for SEM analysis using a sputtering technique. This process involves the use of 20-30 mA of current and...

05 November 2023 3,827 2 View