Hello everyone,
I am new to LabVIEW, right now we need to control the movement of an ethernet-based stage drive. We got the sample code from a collaborator but their instrument is USB-based, so we changed it a little bit to make LabVIEW understand the ethernet input, however, it does not work. Could you please have a look at the code and point out what we are missing? We already make the NI MAX recognize the input of the device, as follows. What do we need more? Thank you so much.
I can't give more details since it's been 25 years since my last Labview sting, but quicly looking at the sample and your code, you are missing the VISA libraries; these are a communication protocol that do the actual handshake to your device, and are needed no matter the interface if I remember correctly. Try and look up examples of using the VISA templates.
Also, you need to see your device and its driver recognized in NI-MAX, and from what you posted it doesn't seem to be the case
- Badges
- Science topic
- Similar topics
- Filing