Is there sensor history output for energy ALLKE and ALLPD in abaqus 2020?

is there sensor history output for energy ALLKE and ALLPD in abaqus 2020? is there any one help me

19 November 2020 6,699 2 View

How can I invoking energy output in subroutine such sensor. the sensor can invoke output scalar such V. ?

07 November 2020 4,471 1 View

How can I invoking energy output in subroutine such sensor. the sensor can invoke output scalar such V. ?

07 November 2020 5,141 1 View

What kind of amides does the tendon consist of?

In visible reflectance spectroscopy performed on a bovine tendon, peaks were observed corresponding to tendon amides. But I do not know these peaks are related to what kind of amides.

16 August 2020 4,411 3 View

How to estimate Mean +SD for subgroups in a study in which results are presented for the main population?

Hello, I started working on collecting data for meta-analysis and I faced two-phase study, which in the first experiment the pharmacokinetic profile of 15 patients after drug administration were...

04 April 2020 9,678 3 View

What is my fault for getiing Push over curve for analyzing shear wall with connection ( Link element) on SAP2000?

Hi everyone. I modeled a shear wall with link elements as connections on SAP2000 but I have a problem with getting the correct push over curve for that ( I can't get the target displacement...

28 January 2020 8,261 3 View

How to calculate the life of a pixel if we know the useful life of LED?

For example, if the resolution of one LED is 2073600 pixels per image and the LED has 5 years useful life, how is the average life of each pixel calculated?

10 November 2019 9,565 2 View

What technologies can we expect to see have the biggest impact on maritime in 2030?

I think the autonomous systems, artificial intelligence, virtual reality, big data, cybersecurity and evolution of marine automation will probably be the next year's issues. What do you think?

10 April 2019 7,135 10 View

Mechanical Behavior and motion simulation in ansys maxwell ?

Hi. I want to simulate a motion in Ansys Maxwell, meaning that I want to simulate 2 magnets, one fixed in its place and the other can rotate around its center point ans as you know, the free...

14 January 2019 208 3 View

Which internal standard is suitable for running an organic reaction whose conversion will be analyzed by HPLC?

I want to run an organic reaction and determine its conversion by using HPLC since I am using water as solvent and cannot use GC for conversion determination. Since HPLC cannot detect typical...

01 January 2019 6,428 3 View

Looking for Materials with high thermal expansion coefficient and high temperature resistance?

03 March 2021 8,272 1 View

Can we classify HV and LV lines based on line length?

I have dataset which shows the length of power lines. I need to classify the lines based on the line length. Is there a rule to classify the High voltage (HV) and low voltage (LV) lines based on...

03 March 2021 4,116 4 View

What solvent can I used for Paal Knorr reaction between 6-amino hexanoic acid and 2.5 hexanedione?

I am try to make the Paal Knorr reaction between 2.5 hexnedione and 6-amino hexanoic acid, my problem is type of solvent to use, because 6-hexaminohexanoic acid is soluble in water but I am not...

02 March 2021 4,443 2 View

Waters 2707 HPLC autosampler problem?

I am using a 2707 waters HPLC device. When I try to inject a sample, it says missing plate or rack. I changed the needle and calibrated its position but I still get the same problem. I even get...

02 March 2021 1,408 1 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

Why almost every element would be metallized in sufficiently high pressure and low temperature?

(This statement is from wikipedia, BTW). What is so special about metallic bond that is limiting high-P low-T state of a matter (as long as individual atoms exist, not white dwarf of neutron star...

02 March 2021 3,309 2 View

How optimize the Size Exclusion Chromatography?

Hello! I'll do a size exclusion chromatography, but I only have an open column, and I'll perform the peptide extraction from yeast, using buffer lysis (sodium phosphate 50 mM/NaCl 30 mM/DNAse and...

01 March 2021 2,215 2 View

Does anyone know HRM channel in a 2 plex QIAGEN Rotor- Gene Q qPCR can be used as a separate channel?

I am going to have 3 different probes in my qPCR work that I am going to do. But I realized that the machine we have in the lab is a Rotor-Gene Q 2plex HRM Platform, saying it has green, yellow,...

01 March 2021 8,544 1 View

I have designed reflectarray element and feeding it though Horn Antenna on HFSS. After full wave simulation, I am not getting desired results?

I have designed reflectarray element to generate OAM beams at 5.8GHz and feeding it though Horn Antenna on HFSS. After full wave simulation, i am not getting desired results i.e Radiation pattern...

01 March 2021 9,701 5 View

Precipitate after adding laemmli buffer to protein solution containing Potassium Acetate?

Hi, I am running a size exclusion chromatography experiment with a buffer containing Potassium Acetate as a salt. I analyse these fractions through SDS-PAGE. After boiling my SEC fractions in...

01 March 2021 2,622 3 View