I need to determine whether any recombination events have occurred in genes I have sequenced.
Hey Chantal,
I used Simplot (in particular a Bootscan) for detecting recombination hot spots.
Hope that helps.
Good luck
-Ijad
http://sray.med.som.jhmi.edu/SCRoftware/simplot/
Thanks everyone.
Does someone knows what's the full name of Eisenia rosea (Savigny), including the publication year and whether or not auteur and publication year should be in between brackets. Best...
24 February 2024 2,352 2 View
I am measuring Calcium concentrations in Ca-EGTA solutions that are used in single fiber measurements. I am observing different outputs on different days of measuring. Is that due to the activity...
20 July 2021 3,393 0 View
Hello everyone, I am conducting a meta-analysis and there are two major outliers in the results that seem to be confounding the results of the publication bias analysis. We ran Egger's test and...
15 June 2020 5,123 2 View
I also want to cite from this article: https://www-sciencedirect-com.vu-nl.idm.oclc.org/science/article/pii/S1053482217301055 However i does not contain page numbers. How would you refer to this...
23 January 2019 9,039 2 View
What is the lowest known detection limit of microplate testing for identifying antifouling agents? See : "A marine bacterial adhesion microplate test using the fluorescent DAPI dye: a new...
02 August 2018 2,091 6 View
I am conducting a mesocosm experiment in 68L outdoor totes investigating the potential of gamma irradiation to detoxify oil sands tailings waste. One of the ways I am assessing the effectiveness...
11 December 2017 8,565 0 View
After coating cell culture plates, I leave them to dry in the flowhood (without lid) for about 2-3 hours, then put the plates upside down in a fridge (4 degrees C) inside a closed plastic bag....
27 November 2017 1,799 0 View
Jmodeltest doesn't seem to work, I'm told input data is too large. Any other recommendations?
25 May 2017 3,943 2 View
Hi, my moderated mediation analysis (process model 7) revealed a marginally significant interaction effect (p=.085). In the results part I therefore decided to marginally support my hypothesis....
24 May 2017 389 1 View
I am conducting a mesocosm experiment in 68 L rubbermaid totes examining the differences between gamma irradiated tailings waste (treatment) and non-irradiated tailings waste (control), we believe...
05 December 2016 8,614 2 View
I would like to learn more about SPSS and Its application especially in regards to data analysis. Please suggest me how I can learn more about it. Thank you so much.
11 August 2024 9,101 4 View
I have reverse sequences (AB1 format), can I base on reverse DNA sequences to perform nucleotide alignment, convert nucleotides to amino acids and deposit the sequence in GenBank database?
11 August 2024 5,138 1 View
Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!
11 August 2024 3,770 4 View
Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...
10 August 2024 7,180 0 View
I'm currently exploring the application of Python in textile engineering, specifically in areas like data analysis, process automation, and the development of smart textiles. I'm interested in...
10 August 2024 7,429 2 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
I'm cloning a fragment of 3200 nts into plasmid. The cloning was successful, however, 02 amino acids were mutated. Now I want to fix these 02 aa by site-directed mutagenesis technique using...
08 August 2024 4,645 2 View
Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...
07 August 2024 1,937 1 View
A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.
07 August 2024 5,307 1 View
Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...
07 August 2024 8,106 4 View