I am interested to work with In2O3 nanoparticles for surface coating. It is necessary to know it's behavior.
Before to start work with nano fertilisers, it is important to know the advantages/disadvantages of nano fertilisers for application in Agri-sectors.
09 October 2018 2,538 1 View
Research scholar, Co-Guide & Guide perform an experimental work & then they prepare a research paper. As it is a team work, a procedure should be followed to measure for author's...
09 October 2018 1,978 0 View
What is DOI & why ?
09 October 2018 9,874 0 View
I want to continue my research work with Indium nanoparticles. So, it is important to know how much it safe nanoparticles?
09 October 2018 7,335 0 View
What are the procedures to measure the thickness of thin film?
09 October 2018 6,414 0 View
What are the advantages of TiO2 coating over SiO coating on copper substrate for pool boiling heat transfer?
09 October 2018 8,779 0 View
We want to work for enhanced pool boiling heat transfer of refrigerants on TiO2 nano coated surface, fabricated by sol gel technique. So, it is essential to prepare TiO2 nanocoated surface over...
09 October 2018 727 0 View
How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...
10 August 2024 942 3 View
I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.
09 August 2024 9,894 2 View
I did PR spin coating on trench structure. I used AZ P4620 PR and the thickness or PR is around 11um. The substrate is Si. And my trench structure depth is 141um(negative way). Even though I...
08 August 2024 2,298 0 View
A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.
07 August 2024 5,307 1 View
I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.
07 August 2024 4,526 4 View
I have been using paraffin, but the deposited ZnO still detach from electrode. What is the best binder to modify graphite paste electrode with ZnO nanoparticles?
03 August 2024 4,624 3 View
Hello, if you made a transwell assay where you incubate the cells with a nanoparticle-encapsulated drug and considering that in the oposite compartment you'll have both the free and encapsulte...
03 August 2024 2,730 1 View
Following curve related to Co0.6Mn0.4Fe2O4 Magnetic nanoparticles with extra phase a-Fe2O3. I will appreciate to help me to interpretation this spectroscopy, especially the blue line.
31 July 2024 9,140 2 View
I am trying to coat my micelles and PLGA based nanoparticles with cell membrane using an Avanti mini extruder according to literature . I use 200nm membrane but my particles end up to be 400nm And...
30 July 2024 3,294 3 View
I went for Plackett Burman Design for selecting the optimization factors of growth conditions for pesticide degradation. I started with 7 parameters. But, after the experiments and analysis, only...
29 July 2024 5,015 1 View