What are the procedures to measure the thickness of thin film?
Research scholar, Co-Guide & Guide perform an experimental work & then they prepare a research paper. As it is a team work, a procedure should be followed to measure for author's...
09 October 2018 1,866 0 View
Before to start work with nano fertilisers, it is important to know the advantages/disadvantages of nano fertilisers for application in Agri-sectors.
09 October 2018 2,431 1 View
What is DOI & why ?
09 October 2018 9,776 0 View
What are the advantages of TiO2 coating over SiO coating on copper substrate for pool boiling heat transfer?
09 October 2018 8,663 0 View
I want to continue my research work with Indium nanoparticles. So, it is important to know how much it safe nanoparticles?
09 October 2018 7,223 0 View
We want to work for enhanced pool boiling heat transfer of refrigerants on TiO2 nano coated surface, fabricated by sol gel technique. So, it is essential to prepare TiO2 nanocoated surface over...
09 October 2018 632 0 View
I am interested to work with In2O3 nanoparticles for surface coating. It is necessary to know it's behavior.
08 September 2018 3,597 0 View
Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.
28 February 2021 3,640 3 View
24 February 2021 2,362 5 View
As it is highly probable that pellets will have a higher degree of air gaps and voids than thin films, is it possible to pole the samples with corona poling nevertheless? Or is there the...
24 February 2021 1,349 1 View
I am trying to characterize an electrochromic system. The system uses ITO electrodes on glass, WO3 as the electrochromic film, and NiO as the ion storage layer. When I deposit NiO and WO3 and...
23 February 2021 9,592 2 View
I want to deposit multilayer coating of germanium and silicon monoxide on silicon wafer using ebeam evaporation?
21 February 2021 2,141 3 View
I want to measure the thickness of aluminum oxide and titanium oxide layers deposited on textured glass substates. The layer thicknesses are typically below 100nm.
21 February 2021 5,465 4 View
I have done Uv-vis characterisation of my thin film and have received absorbance and transmittance data. Now I want to calculate the absorption coefficient but I dont know the thickness of my...
21 February 2021 7,148 8 View
Is there any way to construct different initial filler shapes like triangle, square, rectangle, pillar, and tube in any simulation software.
20 February 2021 1,750 1 View
As fractal dimension of a thin film surface implies the irregularity in the surface. Is it possible that the energy states of the electrons are also affected by the fractal dimension?
19 February 2021 5,509 3 View
what is the reason film thickness increased when increased doping concentrations give some reasons The measured film thickness is 156, 282, 394, 548 and 681 nm for 0, 1.5, 2.5, 3.5, and 4.5 wt....
17 February 2021 8,987 5 View
