The input that I have used folows the SI (mm) my density is tonne/mm3, stress is MPa.
After i have completed the simulation and opening the visualisation to see the results, are the stress values I am seeing in MPa too? I have attached my results below.
Thanks in advance!!
Dear Jerin Wesley R
the dimensions that can be used in ABAQUS attached below.
If you have used consistent units in your input model (e.g. SI mm), the resulting stresses will indeed be in MPa (N/mm²)
Are you consistent? I see that you defined the density in tonne/mm3!
Shouldn't be in Kg/mm3?
If you use mm & Mpa and sukd be the density in kg/mm3, there yes the result will be in Mpa
Hi Ahamed Jubara and Ayad Kakei,
I noticed that you mentioned density shld be in kg/mm3.
Can i double chece with you on this as from the abaqus slides that i have it says it is in tonne/mm3
- Badges
- Science topic