Dear All,

A cracked plate (through-thickness crack) is repaired with composite patch and is modeled in Abaqus. Now, I want to model the crack propagation after repair process, but there are some issues related to tie constraint between plate surface and the Adhesive. When I tie all Adhesive and plate nodes on the shared surface to each other using the "tie constraint", there is no propagation, although the propagation criteria are completely met.

I think the problem comes from the "tie" procedure. I tried to remove the nodes on crack direction line from the tie constraint, but still got the same results. Any advice would be appreciated.

Regards,

More Mohammad Malekan's questions See All
Similar questions and discussions