I'm looking for a suitable human neuronal cell line for neurotoxicity or neuroprotection screening. Which human neuronal cell model is best for high throughput screening? Can anyone help?
You can please refer to the links below to obtain certain valuable informations:-
1. http://www.ncbi.nlm.nih.gov/pubmed/24705302
2. http://www.ncbi.nlm.nih.gov/pubmed/23917397
3. http://alttox.org/mapp/toxicity-endpoints-tests/neurotoxicity/emerging-science-policy/
For such studies, SH-SY5Y OR IMR-32 cell line can be used.
Thanks Sandip and Nishith
Xc= (&-&a)/(&c-&a) and we have Xc 32% and &=0.91g/cc calculate the &a (amourphous density )= ? &c (crystalline density of polymer)= ?
19 January 2023 2,973 3 View
Both BHAR and CTPR are standard methodology widely followed to measure the long run firm performance.
21 December 2022 8,822 0 View
This is in context of the objective function of a multivariate optimization problem say, f(a,b,c). I am looking for a "measure" for the degree of bias of f(a,b,c) towards any of the input variables.
15 November 2022 7,522 4 View
I need to do the proteomic profiling of some of my experimental samples. Please let me know if anyone has the contact number or email ID of such service providers. Thank you!
20 October 2022 10,023 0 View
Finite element simulation of diffusing bonding of steel and aluminium subjected to temp of 500 0c and load of 15tonne in vacuum.
03 March 2020 1,511 2 View
Transition state from Gaussian QST3 must have imaginary frequency. For zero point energy correction if someone takes this frequency then it'll be erroneous. My concern is that whether Gaussian 16...
25 August 2019 2,464 2 View
Hi, I have a design for source-follower low pass filter which I intend to use with a switched mode power supply. I simulated the circuit in NI Multisim, and for square wave ripple voltage of...
03 January 2019 3,261 9 View
literature, FE modelling / analysis, failure
15 September 2018 6,865 1 View
I came across this term in a paper by A Lima 2003. Please make me understand the basic concept and how can I apply it in continuous field.
17 June 2018 1,329 0 View
I want to calculate the complexation energy of two stacked aromatic system. If I use counterpoise correction then does it not consider non covalent electron delocalization (n to sigma* or pi to pi*) ?
02 January 2018 3,600 0 View
Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...
11 August 2024 8,141 3 View
I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...
09 August 2024 9,621 0 View
Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...
09 August 2024 2,824 3 View
I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...
07 August 2024 7,535 4 View
Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.
07 August 2024 8,782 3 View
Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...
07 August 2024 8,106 4 View
Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...
06 August 2024 641 2 View
I am planning to collect human fecal samples for metatranscriptomic analysis using MGI. These samples are from indigenous people living in a region with high temperatures. I will have access to a...
06 August 2024 1,367 3 View
I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...
05 August 2024 454 3 View
A Markov-like Model for Patient Progression" Markov Chain Monte Carlo (MCMC) Markov Chain Monte Carlo (MCMC) is a powerful computational technique used to draw samples from a probability...
05 August 2024 10,079 0 View