When is it unnecessary to change organisational culture?

As a former management practitioner, I recall a generally accepted view that changing organisational culture is difficult, so you should only attempt it if the organisational change that you are...

27 February 2021 2,595 8 View

Can I use a protein-devoid condition as my negative control in ELISA?

Hello, I am running a sandwich-type ELISA where I am trying to inhibit a protein-protein interaction using small molecules. For each experiment, I determine my Z' (Z-prime) to determine the...

23 February 2021 7,429 1 View

Will SARS-CoV-2 Spike be broken into S1 and S2 by denaturing conditions?

Hello, I am performing a western blot of my SARS-CoV-2 Spike-pseudotyped lentiviral particles. I denature my virus by adding concentrated virus to 2X Laemmli buffer at 1:1, then boiling for...

17 February 2021 4,844 4 View

What is the best temperature to coat an ELISA plate?

Hello, I want to control the temperature of my ELISA plate during incubations to get consistent results. In general, what is the best temperature to coat the plate with antibody? I have been...

16 February 2021 2,377 7 View

SPSS - Merging files by ID numbers that contain letters?

Hi, I'm trying to merge files from a data base of 20 files, each containing about 4000 subjects. Unfortunately the ID numbers are actually a combination of numbers and letters (e.g., b1458219)....

15 February 2021 5,833 3 View

How would I go about getting an expert review on the interview questions for the dissertation?

Good Evening, My name is David Marshall and I am Doctor of Management Student at Colorado Technical University Online. I just recently received approval from the IRB to start data collection on...

08 February 2021 346 7 View

How can I quantify the color of a solution?

I know colorimetry has been the standard way by way of measuring the concentration of a particular compound (solute) in a colored solution (solvent or measure quantities of a particular compound...

08 February 2021 2,673 1 View

ACE2 Blotted as a double band?

Hello, I have recently run a western of Vero cells for ACE2. I detected ACE2 at the correct size, but it presents as a double band. The sample was prepared by lysing cells in 1X Laemmli...

07 February 2021 6,973 3 View

SARS-CoV-2 Spike Protein Western Bands?

Hello, I am western blotting SARS-CoV-2 spike protein from lentiviral using an antibody against S1. To prepare samples, I mixed concentrated lentivirus 1:1 with 2X Laemmli buffer and boiled...

07 February 2021 3,643 4 View

How does DMSO percentage affect ELISA?

Hello, In my sandwich-type ELISA which is testing for small molecule inhibition of a protein-protein interaction, it seems that DMSO percentage and dilution protocol are important. I...

31 January 2021 6,771 1 View

Which is the most efficient etching solution for nickel based alloys?

Which solution reveals the microstructure and features of nickel-based alloys?

02 March 2021 2,221 3 View

Which reagent is best among 'Dimethylglyoxime" and "Dithiothreitol" for spectroscopic determination of Nickel ?

What I think is Dithiothreitol. As it is water-soluble and does not form a precipitate. But, the thing is it contains sulphur which is quite hazardous to aquatic animals.

01 March 2021 8,374 4 View

How can I selectively dry etch Ti on a polymer substrate?

24 February 2021 5,378 1 View

How to delaminate copper in water-based anodes?

Hello everyone, I'm looking for a way to delaminate copper current collector of water-based anodes in Li-ion batteries without damaging the graphite film. I tried different materials such as HNO3...

24 February 2021 3,785 3 View

What is the best etching method for Mg-Ca alloy?

I have used Picral etchant (4.2 g Picric acid, 10 mL Acetic acid, 70 mL Ethanol, 10 mL distilled water) but it didn't work. Is there any alternative?

21 February 2021 2,558 5 View

How to modify micro-structure of Pure Copper which is available as a flat plate of 25 X 25 sq. cm?

Hi everyone, for a thesis project I have to modify the micro-structural properties of pure Cu flat plate of dimension 25 X 25 sq. cm . As I tried searching the available literature, I found a lot...

09 February 2021 5,090 3 View

Can I use aluminum or copper based substrate for DNA origami imaging using SEM?

As suggested in the title I want to image my DNA nanoflowers/origami using SEM. These nanoparticles are an organic-inorganic particle made out of highly packed DNA and also contain magnesium...

28 January 2021 3,343 3 View

Is it possible to highly selective remove a fused silica template from PDMS by laser-induced backside wet etching (LIBWE) method?

Hi everyone I'm trying to pattern circular cross-section microfluidic channels in PDMS. The template is an optical fiber with an axially non-uniform diameter. To the best of my knowledge, there...

22 January 2021 2,352 2 View

What should be the current and voltage for nickel coating of around 15 micron for steel specimen and also the bath composition?

I need the complete setup information.

21 January 2021 6,455 4 View

What is suitable etching resist coating for polished Titanium Grade 5 surface?

Currently we start a chemical etching project. This project involved etching a polished titanium grade 5 surface part. We facing a problem where by our etch resist coating peel off during etching...

15 January 2021 1,592 3 View