Hi friends.
I built the microstructure model of dimensions (50 micrometer * 50 micrometer ) and when i meshed it, i could not large zoom on model in detail. Can anyone help me ?
Additionally , the approximate min. size limitation in part module is 0.001 .
thanks.
If the microstructure model dimensions limits lies outside the suggested range, you should consider adopting a different set of units.
Change your unit system.
re-wording the previous answer, ABAQUS has no units built into it except for rotation and angle measures. Therefore, the units chosen must be self-
consistent, which means that derived units of the chosen system
can be expressed in terms of the fundamental units without conversion factors. So, in your case you can consider micrometer is your dimension unit and change other quantites (material properties, ect.) to be in micrometers. Hope this helps
- Badges
- Science topic