Dear researchers.
I've modeled an Eglass/Epoxy composite plate containing a hole in the center and is tensile-loaded from both sides. Hashin progressive failure in Abaqus software is used to see damage in all failure modes. As i excepted , for example Matrix Tension Failure, matrix damaged regions should be shown in HSNMTCRT parameter in Abaqus results but as you see in attachted figure (1), in spite of different amounts of HSNMTCRT parameter, all model have the same gray color .
Why ? Do certain settings are required in the software ?
Thanks
https://www.researchgate.net/post/What_is_the_indication_of_grey_colour_in_a_contour_plot_in_Abaqus_software_output
Dear Manish
Thank you to your link . I set the max/min value in contour option in visualization module but the problem did not resolved yet .
is that right ?
Is these values meant for some other region ? Did you checked other contour plot like Max stresses, strains ,etc.- ? Is it all the contour plot shows gray color ?
- Badges
- Science topic