Laser repair company in Europe.

05 May 2012 1 3K Report

Does anyone know a company in Europe that can repair a Coherent Enterprise II laser system. It is a UV laser (351 and 364nm) with an air cooled power supply.

Josef Gotzmann

Coherent itself also has technicians in Europe (e.g. Germany). DO you know what's wrong? do you have tube current but no light - check the fiber?

Badges
Science method

More Manel Bosch's questions See All

Ratio imaging experiment with two excitation wavelengths and one emission.

I would like to know your opinion about a ratio imaging experiment with two excitation wavelengths and one emission. Is it acceptable to change the acquisition conditions (time, gain) between...

01 February 2013 4,985 8 View

How can I prepare virus for a TEM or SEM imaging?

I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?

11 August 2024 3,115 1 View

Is there anyone with experience in TEM analysis who can assist with a manuscript for an upcoming journal?

Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...

07 August 2024 9,563 0 View

Weak DAPI staining after immunohistochemistry - how to improve?

After immunohistochemistry of previously fixed in PFA and EtOH and then frozen 20 μm sections of zebrafish brain, DAPI staining is very weak (right) compared to the same sections stained without...

05 August 2024 9,637 2 View

Which distribution type should I use when calculating the average particle size from TEM image? and how to calculate the error ?

average particle size calculation from TEM

04 August 2024 2,921 1 View

Is it necessary to covary exogenous constructs in a structural model?

I am working on a SEM model where i have 7 latent variables (6 exogenous and 1 endogenous). In AMOS when I co-vary the exogenous constructs, only 2 paths are coming significant out of 6. But when...

03 August 2024 6,028 4 View

In SEM, if a latent variable consists of three observed variables, and each observed variable has four items, what should I do?

Suppose I am studying the construct of "Academic Motivation" (latent variable) in students, which is measured through three observed variables: "Intrinsic Motivation," "Extrinsic Motivation," and...

31 July 2024 3,913 6 View

Please guide me how to prepare samples for zeiss confocal microscope?

i am working on ischemic stroke. for immunoflourescence i want to use zeiss confocal microscope.before i used VS120 but the images from vs120 not so good now i want to use zeiss confocal but i...

30 July 2024 2,349 1 View

I have synthesized a composite of ZnO and In2O3 with variations in ZnO content. In Raman , what is the peak observed at 130 cm-1?

Dear all, I have noticed, as the ZnO content increases, the Raman intensity at 100cm-1 also increases. However, there is a peak nearby at 130 cm-1, which I could not find in any paper related to...

28 July 2024 5,410 1 View

Bootstrapping in SEM Amos ?

Can a researcher use small sample size of 40 while using SEM with bootstrapping of 1000 and is it possible to get published

28 July 2024 4,402 2 View

Does it exist some special technique for cutting ceramic membranes for Cross-sectional FESEM images?

Does it exist some special technique for cutting ceramic membranes for Cross-sectional FESEM or SEM images?

25 July 2024 5,482 2 View