Can anyone suggest me a good source to find LCI of smart box/energy box use in PV off-grid power system ?

Smartbox or energy is an important item of a solar power system. I would be grateful if someone can help me/suggest a literature source to find life cycle inventory of the smart box. Thanks.

25 November 2020 1,542 1 View

Is it possible to get a small heater 30*30 mm size, which can work up to 200 degrees C?

Is it possible to get a small heater 30*30 mm size, which can work up to 200 degrees C? As part of my research, I need a small heater 30*30 mm size with the thermostat, which can work up to 200...

15 September 2020 8,632 3 View

No title

I am using iron oxide nanoparticles for metal adsorption studies and observed that two different particles (two colors and sizes) existing. the manufacturer sells them as magnetite nanopowder. I...

14 March 2018 9,362 8 View

What is the best method to isolate viable single cells from fresh adult mouse/rat brain?

I'm trying to isolate viable single cell suspension from brains harvested from 2 month old mice/rat. I'm specifically looking for enzymatic methods of dissociation. I understand pappain works...

18 August 2014 4,633 4 View

Which plates should I use for AlamarBlue assay?

Cell viability assay

30 July 2013 4,837 8 View

For polyaniline which one is best solvent nmp or dmf for electrospinning

i want to know form nmp and dmf which one is best solvent for ployaniline in electrospinning fiber formation. can we use pure polyaniline in uniform film formation by electrospinning without any...

01 January 1970 3,020 2 View

Is there a method of determining feed digestibility without the need to re-pellet the feed?

I am aiming to determine the ADC values of a commercial fish feed, but I do not have a steam pelleter or extruder available to me. Ideally, the pellets could be coated with some inert marker....

28 February 2021 7,967 3 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

How to prepare a thin polymer film by post-polymerization/crosslinking?

24 February 2021 2,362 5 View

Is is possible to pole with corona poling pellets of the sample material instead of thin films?

As it is highly probable that pellets will have a higher degree of air gaps and voids than thin films, is it possible to pole the samples with corona poling nevertheless? Or is there the...

24 February 2021 1,349 1 View

How to troubleshoot Electrochromic Films and Electrochromic Devices?

I am trying to characterize an electrochromic system. The system uses ITO electrodes on glass, WO3 as the electrochromic film, and NiO as the ion storage layer. When I deposit NiO and WO3 and...

23 February 2021 9,592 2 View

How to improve the adhesion between germanium and silicon monoxide thin film layers using EBEAM evaporation?

I want to deposit multilayer coating of germanium and silicon monoxide on silicon wafer using ebeam evaporation?

21 February 2021 2,141 3 View

How can I measure the thickness of thin layers deposited on textured glass susbtrates?

I want to measure the thickness of aluminum oxide and titanium oxide layers deposited on textured glass substates. The layer thicknesses are typically below 100nm.

21 February 2021 5,465 4 View

How do I calculate absorption coefficient of my thin film if I dont know the thickness? Or how can I calculate the thickness of my sample?

I have done Uv-vis characterisation of my thin film and have received absorbance and transmittance data. Now I want to calculate the absorption coefficient but I dont know the thickness of my...

21 February 2021 7,148 8 View

How to construct different filler shape in MD simulations?

Is there any way to construct different initial filler shapes like triangle, square, rectangle, pillar, and tube in any simulation software.

20 February 2021 1,750 1 View

Can fractal dimension of thin film surfaces affects the electrons energy states?

As fractal dimension of a thin film surface implies the irregularity in the surface. Is it possible that the energy states of the electrons are also affected by the fractal dimension?

19 February 2021 5,509 3 View