Hi all. I am running a static structural analysis on a glenoid implant that will be fixed to the base via press fitting technique. How do I show this on ANSYS. I read a paper where the author "pre-stressed" the "cavity" where implant will sit, by displacing it by a certain distance (to increase the cavity size so that the implant can easily sit in the cavity), then after the implant was fixed in the cavity, removed the displacements on the cavity (to bring the cavity back to original size) and then in a different time step applied the load in the implant.

How to I increase the displacement on the periphery of the cavity to increase the size?

More Siddhant Thakur's questions See All
Similar questions and discussions