How to obtain luminous power in watt /m^2 in silvaco LED simulation ?It normally solves for W/cm. What is the V-I characteristics of perovskite LED?

More Robin Sarker's questions See All

Dimensions of an MJ Research 96-well alpha module?

Can anyone with an MJ research / BioRad PCR machine from ~2010 or earlier tell me the external measurements (LxWxH) of the removable standard PCR alpha modules that can be removed from a PTC200 or...

30 July 2024 2,867 0 View

Can the MDFT mental health care model help reduce drug addiction?

This question might come up in my research on "Frustration, Fantasy, and Drug Addiction," where I'm also trying to figure out how to overcome mental health issues without turning to drugs.

30 June 2024 5,936 0 View

Protura for dummies?

Is it possible to tell Proturan families apart based on overall appearance? All the keys I have seen are based on very fine characteristics only readily visible on a slide. Also, there seem to be...

14 June 2024 6,334 0 View

Is it necessary to perform both forward and reverse Sanger sequencing to verify the presence of a gene in a sample?

Hello :) I am looking at the presence of toxin biosythensis genes in lake sediments. Nothing fancy, since I only want to verify the specificity of PCR results for primers related to marker genes...

27 May 2024 392 4 View

Is it common practice to verify PCR results with Sanger prior to NGS?

Hello, Since a large part of my budget will go on NGS and I don't have the money to repeat it, I want to make sure that it will work. The PCR products look good on the gel (nice bands of the...

21 April 2024 7,785 3 View

How do you do rounding in APA for R Square when the value is .001?

So I know we should round the value of R Square to two decimal points, but how should you do it if the value is .001. Should you report it as R2 = .00, or R2 = .01?

26 March 2024 1,387 2 View

Sections with CMC than OCT for spatial transcriptomics slide using Visium HD?

Has anyone run slide in Visium of tissue sections (Heart, kidney, brain) with CMC than OCT for spatial transcriptomics ???

14 March 2024 243 2 View

Can anybody tell me how to analyze the Spearman correlation coefficient, rs between knowledge and attitude for KAP-based research?

I got stuck in analyzing the correlation factor.

23 February 2024 8,045 3 View

How can I measure the quantity of hydrocarbon based material (i.e., paraffin oil) in a soil sample?

I aim to measure the concentration of hydrocarbon based organic compound from a certain quantity of soil sample. I would really appreciate it if anyone can give me some experimental guidelines.

07 January 2024 2,549 1 View

How long does it take until access to a writing is granted after the request?

I've requested access to "Black People under the Black Flag - Arne Bialuschewski" and since this is my first time using this program i wanted to ask, how long it normally takes to get access to a...

14 December 2023 9,128 1 View

Could dyes amplify the spectrum of light to a specific wavelength?

I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...

05 August 2024 3,290 1 View

What is the ionic radius of Hydrogen anion? And how to know the exact ionic radii of the elements?

I'm trying to calculate the tolerance factors of the hydride perovskite and the value calculated by me and the reported values are contradictory. Need more clarity in using the correct ionic radii...

01 August 2024 2,614 1 View

Can a Conventional 50W visible LED Lamp Emit UV Light?

I'm researching light sources and their UV emissions. I'm curious if a 50W, 7500K conventional LED lamp emits any UV light. I found that a 200W tungsten lamp can emit up to 1.5 mW/cm² at 350 nm....

31 July 2024 3,843 7 View

How can I calculate AlGaN/GaN HEMT Breakdown Voltage on Silvaco TCAD?

Hello, I'm newbie to TCAD. I wanna calculate Breakdown Voltage of AlGaN/GaN HEMT. But, my code shows just saturation. Could you please help me how to simulate Breakdown Voltage of my code? And...

25 July 2024 3,738 1 View

What should be the best Lumens range for T8 (120cm) full spectrum LED lamp tubes?

Please (for Arabidopsis), what could be a good Lumens and color range (Kelvin) range for full spectrum LED lamp tubes size T8 (120cm) for each shelve measuring 130x50 cm (length x width) and 60 cm...

11 July 2024 6,078 1 View

Taking a cut line through deck build in silvaco?

Hi everyone hope your all doing good. I’ve been looping my scripts and am trying to take a cut line of the conduction band energy with respect to y for each loop. Basically, I want to take a...

03 July 2024 9,134 1 View

How to define LaZrO2 material with high dielectric value in silvaco atlas?

I'm trying to use this novel material (LaZrO2) as a gate oxide in SOI using 'user.material' syntax but getting an error

28 June 2024 3,150 1 View

How to set the background of plot to white color in Silvaco Tonyplot?

Figure 1 is my plot, the background will be colored when the quantity is set to electron concentration. While Figure 2 is the figure i want. How to set the background to white color when the...

11 June 2024 8,621 1 View

I want to know where can i find n , k mesoporous peroviskite coefficients?

in this link refractiveindex.info i didnt find i work on a simulation comsol of mesoporous perovskite i want to know the properties optoelectric and n,k coff

09 June 2024 2,071 4 View

Why silvaco TCAD the output characteristic curve current is adverse?

I want curve in paper file.But the result of my simulation is that the current is negative, I don't know why?After I tried to change the drain voltage to positive, the curve was right, but it...

08 June 2024 5,351 3 View