How to find out the leakage current density and trap state densities for perovskite solar cells?

10 October 2018 0 405 Report

Hi All,

I have developed Pb free perovskite solar cells and the performance was checked by measuring J-V analysis under i sun conditions. I want to calculate the eakage current density and trap state densities for the recorded J-V curves. Please help me out to get this.

Thanks

Badges
Science topic

More Khursheed Ahmad's questions See All

Why XRD peak absent in MA3Sb2I9 prepared by two step method compare to the MA3Sb2I9 prepared by one step method?

Hello All Researchers, I have prepared MA3Sb2I9 perovskite film on FTO employing two different approach. The XRD was same except absence of one peak in the MA3Sb2I9 prepared by two step method....

31 December 2019 2,285 2 View

Why peak current Vs square root of scan rate is not linear?

Dear Researchers/Scientists, I have recorded the CVs at different scan rate (100-1000 mV) and plotted the graphs for Peak current Vs square root of scan rate. I have found it non linear. Why it...

08 September 2018 9,433 5 View

How to confirm the formation of new perovskite?

Dear Researchers, I have prepared new lead free perovskite but thier crystal structure is not reported. I have tried but I did not get the crystal too. I have recorded the powder XRD. Please...

05 June 2018 168 3 View

How to calculate the Recombination resistance using Nyquist plot?

Hi Respected Scientist/Researchers, I have done the EIS analysis for the perovskite solar cell device having MA3Bi2I9 as light absorber. I need to calculate the recombination resistance and...

04 May 2018 9,507 1 View

Why the XRD patterns powder form and thin film of Organic-inorganic hybrid perovskites is different?

Hi All, I have prepared the CH3NH3PbI3 perovskite powder and CH3NH3PbI3 film. The powder and Thin films shows two different pattern which are consistent with reported literature. However, i need...

03 April 2018 3,976 7 View

How to calculate Adsorption capacity for dye removal?

I have recorded UV-vis spectra for dye adsorption using metal oxide. Dye concentration= 200mg/L Adsorbent= 25mg The absorption peak was observed at 3.3 (intensity;a.u.) and it was absorbed with...

03 April 2017 2,383 1 View

How to calculate electrochemical active surface area for glassy carbon electrode?

I have done cyclic voltammetry analysis for methanol oxidation using graphene/SrZrO3 composite and it shows excellent oxidation current as compared to the pristine graphene or srzro3. Now i need...

01 February 2017 7,364 6 View

How to measure charge discharge study in mehtrohm potentiostate using Nova software?

I have performed GCD for supercapacitor but not getting proper curve, something is wrong. I have attached the recorded file. Please help to what parameters I have to set and how to set.

31 December 2016 6,685 6 View

Can MnO2 be used as electron transport layer in perovskite solar cells?

Generally, TiO2 or ZnO etc. have been employed as efficient electron transport layer since they have band gap around 3.2eV. MnO2 have a band gap of 2.4eV, can it be used as mesoporous layer in...

07 August 2016 1,923 11 View

How to find out accuracy and precision for modified glassy carbon electrode using cyclic voltammetry?

I have recorded the cyclic voltammogramms for both modified and bare electrode. The study has been performed considering different parameters like effect of pH, concentration and scan rate. The...

05 June 2016 3,098 4 View

Why does blocking with my immunogenic peptide cause nuclear fluorescence in ICC?

Hi all, I am validating a polyclonal antibody raised against human ANT4, through WB and ICC. In most of my controls, the antibody shows very little off-target binding, but when I pre-incubate the...

03 March 2021 5,999 3 View

After a reference from Int J Body Compos Res, can any body help?

Hi, I am after the reference below, my library says it cannot obtain a copy either locally or internationally, any help appreciated! Chris Wang ZM, Heshka S, Wielopolski L, Pi-Sunyer FX, Pierson...

03 March 2021 6,193 1 View

Irradiation data for JAPAN?

Hi, Could you help me to get the latest (2019, 2020) solar resource data for a particular site in JAPAN? PV GIS and NSRDB data are not in reach to JAPAN, I'm looking for some other database for...

03 March 2021 961 3 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

Does Napabucasin soluble in dichloromethane and in ethanol?

I need to prepare a solution of Napabucasin (inhibitor of cancer cell stemness) in dichloromethane. The drug is expensive, so maybe somebody already tried to do it. If it is soluble, what is the...

02 March 2021 9,945 3 View

Help request in CST microwave?

im working now on TPV solar cells and metamaterials and i realy need our help in CST microwave i have a tpv cell simulation and i want to extract particullarly the absorbtion of only the active...

02 March 2021 2,246 2 View

Anyone found any research papers on solar furnace design calculations (for solar concentration)?

I am thinking about working on solar furnace with heliostats that concentrate sunlight and heat molten salt, but currently no luck with research. Not a lot of papers based on the subject. (check...

01 March 2021 5,023 5 View

Which fluorescent dye to use for measuring total ROS production?

Is DCFDA appropriate for measuring total ROS production, or can it only detect certain types of ROS? If I want to measure total ROS production, which dye should I use?

01 March 2021 9,447 3 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

Apart from Nanosilica and CNT's what are the other nanomaterials readily available to use in concrete mixture?

Nanotechnology in concrete materials

01 March 2021 3,379 3 View