How to Fill Up volume in CST MWS
Hello everybody, Does Anyone know how to fill up a generic volume with a certain material using CST Microwave Studio Software? How to connect a curved plate to two flat plates and create the following volume which is shown in below picture Thank you...it's time that I am trying without success...
Omid Niksan
The easiest way to di it is to depict a closed curve. You can first try it with a rectangle. After depicting the curve, you can use the tool "extrude curve" to convert your 2D rectangle to a 3D shape with an arbitrary height. In this case, you will get a cube but in your case, you will get your desired volume.
0 votes
0 thanks
- Badges
- Science topic
- Similar topics
- Physical Sciences
- Materials Science
- Plating
More Niloufar Islamnezhad's questions See All
Similar questions and discussions