How to get the heading of real-time credit card dataset ?

I am working with the Credit card dataset. I am aware of the fact that the Banks and financial institutions do not share the dataset with third-party companies or researchers. I just need to know...

18 February 2021 9,186 3 View

Is there any effective FEM solver to perform simulation of balloon inflation with large deformation (e.g. 300% strain)?

Hi! Thank you for your time, attention, and support. I am currently using FEM solver Abaqus to perform a set of balloon inflation simulations, trying to understand the deformation shape, stress,...

14 February 2021 2,524 4 View

Why are we measuring gel content of NBR latex? Does gel content related to the amount of cross-linked in a polymer?

Hi good day to everyone! I am actually studying the gel content of synthetic latex. Refer to ASTM 3616, gel content is measure of insoluble rubbers in the chosen solvent. So, I just would like to...

07 February 2021 605 4 View

BrdU staining issue?

Hi everyone. I bumped into the difficulty that I couldn't get any signals from my brain section in the DG region of hippocampus. However, I have standardized the BrdU protocol in my brain...

13 January 2021 9,449 0 View

How to delete a copy of a paper, and how to delete a co-author's name?

I mistakenly uploaded a copy of the same paper and entered my alternative name. How to delete them out? (I couldn't navigate to the right buttons to do it. So from where to where is what I don't...

07 January 2021 7,694 6 View

What effect will different solvents have on the ATRP reaction?

I want to do an ATRP reaction, synthesize an ATRP initiator, use DMF as a solvent, and mix DMF, BIBB and TEA to turn red. Why does it turn red? Xylene has been used as a solvent before, and there...

04 January 2021 8,034 3 View

Species identification.Who can tell me the scientific names of these Gastropods?

Species identification. I've been doing research on communities of marine macrobenthos recently, but some of them can't be identified, which hinders my research. Who can help me identify these...

14 December 2020 8,357 3 View

Cell shrinkage during ROS assay(H2DCFDA)?

Hi! I'm Yu, studying about health of MSC. These days, I'm doing ROS assay with H2DCFDA which requires 5~30 minutes of staining with PBS or HEPES or HBSS. In our lab, We use PBS w/o Mg/Ca for...

13 December 2020 8,813 9 View

Can I fix the cells after H2DCFDA assay for FACS analysis?

Hi ! I'm Yu, and planning to analyze ROS assay with H2DCFDA(Thermo) on MSCs. A lot of protocols instruct that treat H2DCFDA at specific concentration for 5~30 min, 20~30 min of recovery time...

10 December 2020 973 1 View

How to reconstruct a Lamb wave by a series of pulses superposed?

Lamb wave is useful for solid structure health monitoring, and it consists many modes. Unlike ultrasonic bulk wave, when given a pulse excitation (for example, 5-cycle sinusoidal pulse), only...

08 December 2020 5,440 8 View

Does the pressure(-600 mmHg) affects pH?

When I conducted the degassing experiment using decompression under anaerobic condition(and I used ferrous based chelating agent), the oxidized ferric were observerd. So, could you tell me the...

03 March 2021 4,892 5 View

New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before?

Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...

02 March 2021 3,024 2 View

Which is a lucid standard comprehensive book to guide on psychological scale construction and its standardization?

02 March 2021 7,082 3 View

LOAD DISPLACEMENT CURVES Stiffness increasing in ANSYS non linear analysis. HOW CAN I CORRECT IT?

Hi. I am doing non linear FE analysis using a new material beam under flexural 2 point loading using ANSYS. I have defined a bilinear material model. The solution has converged. In results I am...

01 March 2021 9,911 3 View

How to choose ANN number of hidden layers and nodes?

Hello, Could you please share any interesting research explaining how to choose the number of hidden layers and nodes per layer in case of regression problems using ANN? Thank you, any help would...

01 March 2021 6,200 3 View

PUC19 as a transfer plasmid for lentiviral delivery?

Hello, Is it possible to use pUC19 as a transfer vector to be packed in using the second generation viral particles packaging system( pMD2.G; psPAX2 plasmids)? As far as I understand it there is...

28 February 2021 4,868 2 View

RIA. How to measure?

When you use RIA, with a control the unknown sample with antibodies, you bare in mind the binding sites of the antibodies. However you still need to measure labelled antigen (radioactive) and not...

28 February 2021 2,133 3 View

How could I take into consideration the weights of observation in a system of seemingly unrelated regressions (SUR) in rstudio?

I build a model of 4 regression equations (probit and OLS) in R studio. I need to take the weights of observations into consideration. While it is simple to do so for every regression equation,...

27 February 2021 1,233 1 View

Can random sampling have inclusion criteria?

As random sampling means that everyone in the population have an equal chance to be chosen, can it have inclusion criteria? My research participants have been chosen based on the inclusion...

26 February 2021 6,905 10 View

What is the most suitable resuspension buffer for TCA/acetone precipitated protein?

I need to extract protein from fermented carbon sources for Bradford assay. Most researchers experiencing insolubility of pellet in resuspension buffer. Please assist me to select most suitable...

26 February 2021 7,129 3 View