How is the edge capacitance of two plates derived in High Impedance Surface of Daniel Seivenpiper?

16 December 2022 0 5K Report

How to derive Equation 5.1.3 in High Impedance Electromagnetic Surface of Seivenpiper? The equation is as follows:

Badges
Science topic

More Li Oliver's questions See All

Problems about acousto-optic coupling in Comsol, how to check whether the moving mesh is correct?

I’m trying to reproduce the acousto-optic coupling simulation in the paper Frequency–angular resolving LiDAR using chip-scale acousto-optic beam steering. LNOI(lithium niobate on insulator) is...

13 August 2024 9,793 0 View

Request Python code?

Request Python code from this article : Gender equity of authorship in pulmonary medicine over the past decade. THANKS!

08 August 2024 6,241 2 View

How to solve the problem of unconscious teeth grinding during sleep at night?

One of my friends, every night after falling asleep, his mouth would make a creaking sound after chewing something. This teeth grinding condition would continue until he woke up, and he didn't...

08 August 2024 1,366 5 View

Are the apoptotic cells is positive for γH2AX ?

It has been documented that apoptotic cells themselves can induce phosphorylation of serine 139 on H2AX (γH2AX) due to DNA fragmentation during apoptosis (doi: 10.1074/jbc.275.13.9390). As γH2AX...

28 July 2024 7,983 2 View

How to get LP fiber modes directly from Comsol?

Hi there, I'm new to modelling with comsol. I would like to ask if it is possible for comsol to output linearly polarized (LP) modes? I tried modelling a simple single mode fiber with an enlarged...

23 July 2024 4,019 3 View

What is the future scope of acoustic emission?

17 July 2024 1,509 1 View

How to understand Instantaneous SINR (ISINR) ?

I read two papers which uses Instantaneous SINR (ISINR) as criterion for performance evaluation. In the two papers below, it seems the desired signal (numerator) in ISINR does not involve...

16 July 2024 4,545 0 View

Why cant I extract force result in LS-DYNA?

I want to extract basement shear force in LS-DYNA calculation result, but i found that there were no force results but only moment results in SPCFORC even I check the model and make sure the...

23 June 2024 2,691 0 View

QUESTIONs about Annexin V/ PI apoptosis experiment: Are these pictures acceptable?

I am evaluating the apoptosis of two types of cells, which are derived from primary mammalian cells (fibroblasts). When I use the Annexin V/PI method, the image I get is like this. It seems not...

17 June 2024 5,569 1 View

How to perform the anaysis of taxonomic on raw reads from the mixed sample?

Hi, I am very new to Bioinformatics. Recently, I have the project that aims to perform taxonomic anlysis on raw reads from mixed samples taken from environment. For example, we perfromed NGS...

09 June 2024 6,536 3 View

Is changing the medium during the experiment overestimate the results?

I am experimenting with cancer and non-cancer cells in a 12-well plate for 4 days with a seeding density 1*10^4/well, however, I noticed that the control group growth rate slows down on D3. Should...

07 August 2024 2,282 2 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,105 4 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,781 2 View

Can you recommend a 96-well plate for minimal cell adherence to the wells during phagocytosis experiments?

I have been performing short phagocytosis experiments using 96-round bottom, tissue culture treated, well plates (Falcon, 353077). I culture the cells with the phagocytic cargo for 2-4hrs, wash...

04 August 2024 5,227 4 View

PBMC infection with virus?

In my study, I intend to infect PBMCs with SARS-CoV-2. After that, I will analyze NK cells by flow cytometry to see if their phenotype changes or if they show degranulation. After the infection, I...

01 August 2024 4,403 4 View

Found this object in the cell culture - do you have any suggestions what it might be?

Dear researchers, Today, we found this object in one of the wells of a 96wp culture plate. The plate contained MEC-1 cells and GelTrex. I am quite curious what this is (because it's not cells). Do...

01 August 2024 2,249 2 View

Publishing a checklist?

Does anybody know of entomological Journals without page charges that would publish an extensive checklist (Hong Kong Aculeates wasps) covering 350 species (of which more than half are new to Hong...

01 August 2024 6,133 2 View

How to calculate conductivity using Electrochemical Impedance Spectroscopy's Nyquist plot?

Hello everyone, I am new to this characterization but watching videos on youtube I have already plotted a Nyquist plot (Z' and -Z'') and already fitted models on my material using Zsim. But now I...

29 July 2024 1,376 0 View

Why semicircle of nyquist plot is not complete?

While I am doing HER, I noticed that nyquist plots of Electrochemical Impedance Spectroscopy (EIS) is not complete. Will it affect for the Linear Sweep Voltametry (LSV) data? However, I can found...

26 July 2024 7,542 4 View

Why specific capacitance is not proportional with the specific surface area?

Dear researchers, Why specific capacitance is not proportional to the specific surface area? I have material A with a surface area higher than material B, but material B is showing little bit...

26 July 2024 9,156 2 View