The pH of my solution is near about 2, and I want to reach it exact 7 (i.e., neutral)
Because I am working in the area of electromagnetic, where electric and magnetic both properties are very important. Suppose if I add base in this solution then its pH is become neutral but it’s reduced the electrical conductivity and simultaneously all the electric and magnetic properties reduced.
Previously, I used DI water for that, but it gives pH only up to 4.8 and after further addition of DI water is not affect the pH.
Also, If I used vacuum filtration, can it neutralized the pH of my acidic solution?
Use a controlled addition of anion-exchanger in the OH-cycle. Add in portions, mix and check the pH. The resin is then filtered off. Clean work. Use one of the Amberlites, for example.
- Badges
- Science topic
- Similar topics
- Biological Science
- Biochemistry
- Biochemical Techniques
- Analytical Chemistry
- pH