Does the moment of inertia round origin is the area moment of inertia?
Thank you so much Dr Germar,
Attached is photo of my result, I do not understand meaning of this statement :
"A unit density and a unit thickness are assumed for all selected areas
even when composite elements are used. "
Another point center of mass calculated in the cmd screen of ansys is different than the computed one through using ASUM command!!!
Thank you in advance
Hi Germar,
I have already defined thickness of surface of the wind blade and provided the density in the material model.
That is what confused me !
How can Rho = 1 but I put its real value in the material model !
and how can Thickness = 1 and I put the values in the section properties.
I will upload the photo on Saturday because I'm not at work and tomorrow is off day.
Thank you so much in advance
how do i get mass and inertia from worksheet into solution to parametrize?
- Badges
- Science topic